1. DL manuals
  2. Da-Lite
  3. Projector Accessories
  4. IDEA Panoramic
  5. Instruction Book

Da-Lite IDEA Panoramic Instruction Book

Other manuals for IDEA Panoramic: Instruction Book

Summary of IDEA Panoramic

  • Page 1

    Instruction book for idea™ panoramic.

  • Page 2

    2 preparation note: it requires at least four people to assemble an idea panoramic. To maintain optimal projected image geometry and screen alignment, a flat and straight wall free from obstructions and angular distortions should be used. Tools required for assembly phillips screwdriver level rubber...

  • Page 3

    3 wall brackets included item number overall dimensions center panel viewing area (h x w) center panel wall brackets side panel wall brackets 27966 36¾" x 144¾" 36" x 64" (2) 28" (2) 28" 27981 36¾" x 144¾" 36" x 571/2" (2) 28" (2) 28" 27963 46¾" x 144¾" 46" x 81¾" (2) 28" (2) 28" 27978 46¾" x 144¾" ...

  • Page 4

    4 assembly instructions for panoramics with 24” marker tray 1. Carefully unpack unit and place all panels on top of the clean work area. The viewing surface of each panel must face down. Note: for optimal seam alignment, use labels on the back side of each panel to arrange for assembly. 2. Slide all...

  • Page 5

    5 wall mounting for panoramics with 24” marker tray note: the screen is shipped with four wall brackets and lengths shipped vary by screen size. Two brackets will be used on the center panel and one bracket on each of the side panels. Measure gap on each side panel to determine which two brackets wi...

  • Page 6

    6 wall mounting instructions for screens with 24” marker tray (continued) 5. Repeat steps 3-4 to install the (4) remaining l-brackets for the side panels. Note: at this point, all six l-brackets will be mounted on the wall; two l-brackets for each panel. Do not proceed if all six-l brackets are not ...

  • Page 7

    7 assembly instructions for panoramics with full length marker tray 1. Carefully unpack unit and place all panels on top of the clean work area. The viewing surface of each panel must face down. Note: for optimal seam alignment, use labels on the back side of each panel to arrange for assembly. 2. S...

  • Page 8

    8 figure 7 wall mounting for panoramics with full length marker tray note: the screen is shipped with four wall brackets and lengths shipped vary by screen size. Two brackets will be used on the center panel and one bracket on each of the side panels. Measure gap on each side panel to determine whic...

  • Page 9

    9 steps 3-8 require at least four people. Place one person on the far left end of the screen, one person at the left panel seam, one person at the right panel seam and one person on the far right end of the screen. More people can be utilized as needed. When lifting the screen off of the clean work ...

  • Page 10

    10 wall mounting for panoramics with full length marker tray (continued) 7. Using all four people, carefully lift the fully assembled three panel screen with the marker trays to an upright position and briefly place underneath the mounted wall brackets. The screen will be parallel to the wall at the...

  • Page 11

    11.

  • Page 12

    Limited one year warranty on da-lite presentation products milestone av technologies llc warrants certain da-lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; pr...