Da-Lite LARGE ADVANTAGE DELUXE ELECTROL Instruction Book - page 3
2
Ifyourscreenwasshippedwiththemotorandrolleralreadyinstalledproceedtostep7.
1. Removefourboltsfromendsofdoorassembly(2boltsoneachend)(Fig.1).Thiswillallowthedoorassemblyto
dropopenforaccesstocase.Forlargersizes,youwillalsoneedtoremovethedoorsupportscrews.
2. Carefullyunpackscreenandrollerassembly.Leavepackingpaperontheroller.
3. Removethesquarepegbracketfromthemotorendoftherollerassembly.
4. Removethesafetyclipfromthemotorattachementbracketlocatedinthemotorendofthescreenhousing.
5. Placetherollerassemblyintothecasewiththemotorontheleftside.Thelimitswitchesshouldbefacingdown.
Lineuptheheadofthemotorwiththemotorattachmentbracket.
6. Loosenfourboltsthatsecurepinendmountingbracketintohousing.Liftpinendofrollerintopositionandslide
thebracketintotherollerpin.Tightenallfourbolts.
7. Completeelectricalhook-upbysnappingmotor1/3wireconnectorsintocaseconnectors.
8. Returntomotorendandinsertsafetyclipovercastingbrackettosecuremotorend.
CAUTION! DO NOT CUT TAPE ON FABRIC WITH A KNIFE OR ANY SHARP TOOL. REMOVE BY HAND.
9. Carefullyremovetapestripssecuringpicturesurfacearoundroller.Slatshouldmovefreely(Fig.2).(Onlyifthe
rollerassemblyispreinstalled.)
10. Testinstallationbyoperatingthescreenseveraltimes.Bepreparedtostopthescreen.Thedoorassemblywillnot
closeuntilthewallswitchisplacedintheuppositionandwhenthescreenmotorstopsatitslimitswitchintheup
direction.
NOTE: Unit duty cycle is 1 minute on, 3 minutes off.
NOTE: Excessive continuous operation may cause the motor to overheat. If this happens the motor will shut off until it cools to
a normal operating temperature.
11. Closedoorassemblyandreplacefourboltsatendsofdoor(2boltsoneachend)(Fig.1).
SCREEN AND ROLLER ASSEMBLY INSTALLATION
SCREENMOTOR
FIGURE 2
DUALMOTORLVC
CONTROLBOX
SCREENMOTOR
LIMITSWITCHES
s
!
DOORMOTOR
DOORMOTOR
LIMITSWITCHES
ACCESSDOOR
ASSEMBLY