Da-Lite Large Cosmopolitan Electrol Instruction Book

Other manuals for Large Cosmopolitan Electrol: Instruction Book

Summary of Large Cosmopolitan Electrol

  • Page 1

    Instruction book for large cosmopolitan ® electrol ®.

  • Page 2

    2 carefully unpack screen and remove outer wrapping from case. Remove the black tape and rubber bands from the slat bar after the case has been installed. The large cosmopolitan® electrol® comes with brackets to allow for wall mount or ceiling mount installations. Procedures for each method are as f...

  • Page 3

    3 large cosmopolitan ® electrol ® installation for screens without a built-in low voltage control internal wiring has been completed at the factory. Installer must route power to the wall switch and to the junction box located on the left end of the screen case. See wiring diagram below for wire con...

  • Page 4

    4 screen adjustment for screens without a built-in low voltage control screen travel is stopped automatically in the down and up positions by the limit switches that are preset at the factory. No further adjustment is necessary. If you need to make minor stop position adjustments see the appropriate...

  • Page 5

    5 large cosmopolitan ® electrol ® installation for 120v screens with a built-in low voltage control rj-45 receptacle rj-22 output rj-22 inputs up (dry contact) down (dry contact) common (both) bus (bus) 5v (bus) up stop down bus c o m 5 v front of wall switch bus up stop down bus c o m 5v led up lim...

  • Page 6

    6 large cosmopolitan ® electrol ® installation for 240v screens with a built-in low voltage control low-voltage wall switch optional ir and rf remote control splitter motor ground to case 240vac 50hz 240v wiring diagram with optional built-in low voltage control up stop down ground–must be connected...

  • Page 7

    7 screen adjustment for 240v screens with a built-in low voltage control 1. Remove the cover plate from the 3-button wall switch and remove the switch from the junction box. 2. Locate small 3-position switch on back of wall switch. See figure 4 for 120v screens or figure 5 for 220/240v screens. 3. T...

  • Page 8

    8 troubleshooting symptom cause solution screen will not operate. Motor does not hum. Blown fuse. Replace fuse. Tripped circuit breaker. Reset circuit breaker. No power to operating switch or junction. Check above. Tighten all loose wire connections. Correct any improper connections. Down position c...

  • Page 9

    9.

  • Page 10

    10

  • Page 11

    11.

  • Page 12

    Limited one year warranty on da-lite presentation products milestone av technologies llc warrants certain da-lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; pr...