Da-Lite Large Cosmopolitan Electrol Instruction Book

Other manuals for Large Cosmopolitan Electrol: Instruction Book

Summary of Large Cosmopolitan Electrol

  • Page 1

    Instruction book for large cosmopolitan® electrol® the da-lite difference. Da-lite screen company llc 3100 north detroit street post office box 137 warsaw, in 46581-0137 usa p 800-622-3737 / 574-267-8101 f 877-325-4832 / 574-267-7804 www.Da-lite.Com e-mail: info@da-lite.Com.

  • Page 2: Save These Instructions

    1 carefully unpack screen and remove outer wrapping from case. Remove the black tape and rubber bands from the slat bar after the case has been installed. The large cosmopolitan ® electrol ® comes with brackets to allow for wall mount or ceiling mount installations. Procedures for each method are as...

  • Page 3

    2 large cosmopolitan ® electrol ® installation for screens without a built-in low voltage control internal wiring has been completed at the factory. Installer must route power to the wall switch and to the junction box located on the left end of the screen case. See wiring diagram below for wire con...

  • Page 4

    3 setting the up limit position caution: do not allow the slat bar to wrap over the top of the roller when the screen is rolling into the case. The screen could be damaged. Screen travels into case too far: turn the up limit switch screw clockwise to decrease the amount of travel. Run the screen up ...

  • Page 5

    4 large cosmopolitan ® electrol ® installation for 120v screens with a built-in low voltage control figure 4 120v wiring diagram with optional built-in low voltage control ground–must be connected to building ground rj-14 pin-outs (tab is facing up) important note: the wall switch is required to mak...

  • Page 6

    55 screen adjustment for 240v screens with a built-in low voltage control 1. Remove the cover plate from the 3-button wall switch and remove the switch from the junction box. 2. Locate small 3-position switch on back of wall switch. See figure 4 for 120v screens or figure 5 for 220/240v screens. 3. ...

  • Page 7

    6 troubleshooting symptom 1. Screen will not operate. Motor does not hum. 2. Incorrect stopping position in downward direction. 3. Incorrect stopping position in upward direction. 4. Noise. Note: screen will operate with a low pitched hum. 5. Coasting. Cause (a) blown fuse. (b) tripped circuit break...

  • Page 8

    Limited one year warranty on da-lite presentation products da-lite screen company llc warrants its products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are properly...