Da-lite screen company, inc. 3100 north detroit street post office box 137 warsaw, indiana 46581-0137 phone: 574-267-8101 800-622-3737 fax: 574-267-7804 toll free fax: 877-325-4832 www.Da-lite.Com e-mail: info@da-lite.Com instruction book for multi vision imager the da-lite difference..
1 important safety instructions when using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an exte...
2 preparation: have space for this available on a flat clean surface such a large table or floor. The work area should be larger than the frame size. If the floor is used, clean papers should be spread to keep all dirt from the screen surfaces. Do not use newspaper. Tools required for assembly: phil...
3 5. Assemble right side of frame to the top and bottom of frame. This is done exactly the same way as the left side. 6. Insert motor phone rj-45 jack into receptacle located at the top of the junction box. Insert motor cable connector to the connector located on the side of junction box. 7. Remove ...
4 wall mount 1. The screen is shipped with two 46” wall brackets. Screens with less than 96” viewing area width (not standard sizes) are shipped with one wall bracket. Two small “l” brackets are included to hold frame securely to wall at bottom. 2. Each wall bracket must be mounted into at least two...
5 multi vision imager installation figure 6 low-voltage wall switch optional ir and rf remote control motor blue (common) brown (hot) green ground to case 240vac 50hz 240v wiring diagram rj9 up stop down ground–must be connected to building ground rj9 green front back up dn gnd +5v 3-position switch...
6 screen adjustment for 220v/240v screens 1. Remove the cover plate from the 3-button wall switch and remove the switch from the junction box. 2. Locate small 3-position switch on back of wall switch. (see figure 6) 3. To adjust the down limit switch, slide the 3-position switch to the down position...
Printed in u.S.A. 71784 rev. 10/11 troubleshooting symptom 1. Screen will not operate. Motor does not hum. 2. Incorrect stopping position in downward direction. 3. Incorrect stopping position in upward direction. 4. Noise. Note: screen will operate with a low pitched hum. 5. Coasting. Cause (a) inco...
