Da-Lite SCB-200 Instruction Book - page 8
8
Figure 5 - NET-200 Connector
NET-200
The NET-200 is an optional daughter board that provides
Ethernet connection to the SCB-200 and may be ordered as a
factory installed option or can be field installed. This Ethernet
adapter allows remote control and status monitoring of a screen
or lift through a connected device. The controls available include
basic up, down and stop controls, as well as advanced controls,
such as custom aspect ratios and precise screen positioning.
The NET-200 is classified as a serial device server, which by
definition means that it makes available to client connections the
Da-Lite screen as a serial device (enabled by the SCB-200.) The
NET-200 supports the full suite of bi-directional RS-232
commands and acknowledgements developed under the
SCB-200, and allows those commands to be issued by any
Ethernet enabled computer or computing device.
NET-200 Installation
The NET-200 connects directly to the SCB-200 low voltage
controller at the position identified. The NET-200 will only fit into
its socket in one direction; do not force the unit. When properly
installed, the Ethernet connector will be facing outward from the
SCB-200.
When using multiple SCB-200 controllers in Master / Slave mode,
the NET-200 should only be installed on the Master SCB-200.
An Ethernet cable may be directly connected to the NET-200
and routed through the cable grommet in the end of the screen.
Optional Controllers (continued)
NET-200 Configuration
The NET-200 is designed for simple, transparent installation and
configuration. By default the NET-200 is shipped with DHCP
disabled. The following IP address is assigned to the NET-200.
IP Address: 192.168.1.100
Subnet:
255.255.255.0
To configure the network settings, type the IP address into your
browser. It will open a new page with the setup profile. A new
window will pop up asking for a user name and password. Leave
the user name and password field blank and press the OK
button.
The new window will contain the configuration browser program.
The menu will be located on the left side of page. Click on
"Network".
Network Menu
OK Button
Blank