1. DL manuals
  2. DAC Limited
  3. Telephone
  4. 711 Series
  5. User Manual

DAC Limited 711 Series User Manual

Other manuals for 711 Series: User manual
Manual is about: Vandal Resistant Telephones 711 Autodial Telephone range

Summary of 711 Series

  • Page 1

    General care and maintenance the 711 telephone does not require any regular maintenance. To clean the telephone wipe with a damp cloth. Do not use any abrasive cleaners on the telephone as this may cause the product to become discoloured. Dac limited distributed by:- user guide vandal resistant tele...

  • Page 2

    Contents page 2 approved facilities page 3 electrical installation page 4 ra711 pcb [key components] page 5 installation page 7 set up features page 8 setting up expansion board page 11 general care and maintenance page 1 this page left blank intentionally.

  • Page 3

    Approved facilities this telephone is designed to operate via a standard analogue telephone pbx or exchange. Any other usage will invalidate the approval of the apparatus and as a result it then ceases to comply with the standards against which approval was granted. Connection is affected by pluggin...

  • Page 4

    Electrical installation line terminal connections and selections the number of telephones that can be connected to a direct exchange line or pbx extension is limited by the ringer equivalence number (ren) of all the telephones connected, this should not exceed a total value of 4. The ren value of th...

  • Page 5

    Hf gain handset hksw hfbuts hfhls hflls load 1 2 line a er b + - power tmr type nrm mic enable disable hs loop lp gain k e y p a d h k t im e dial break mf ld tbr er boot on hk r/p pg mr v+ v- m1 m2 m3 ra711 printed circuit board cn13 page 4 dtmf controller setting up the 711 features. Volume. To ad...

  • Page 6

    Wall surface installation 1. Fix the surface mounting back box to the wall, with cut-out at the bottom, using size 8 or 10 screws with rawplugs (4 off). 2. Connect the cabling, as detailed under electrical connections, and then fit to the back box (as described under wall flush installation, item 3)...