Dac limited user guide vandal resistant telephones 711 autodial telephone range.
Contents page 2 installation page 4 electrical connection page 5 approved facilities page 6 storing an autodial number page 7 set up features page 8 ra711 pcb page 9 setting up expansion board** page 10 command mode page 11 general care and maintenance ** only applicable if a dtmf expansion board is...
Installation the following information is provided for use by the approved installer or telephone network supplier only. The ra711 telephone can be either wall mounted or top-of-pole mounted. Wall mounting can be surface, flush or inset into the wall. Various electrical options are available as defi...
Wall surface installation 1. Fix the surface mounting back box to the wall, with cut-out at the bottom, using size 8 or 10 screws with rawplugs (4 off). 2. Connect the cabling, as detailed under electrical connections, and then fit to the back box (as described under wall flush installation, item 3)...
Electrical installation line terminal connections and selections the number of telephones that can be connected to a direct exchange line or pbx extension is limited by the ringer equivalence number (ren) of all the telephones connected, this should not exceed a total value of 4. The ren value of th...
Approved facilities any other usage will invalidate the approval of the apparatus and as a result it then ceases to comply with the standards against which the approval was granted. Connection is affected by plugging in to the appropriate line socket. If your telephone connection is not fitted with ...
To store an autodial number. Insert the keypad that is supplied with the telephone into connector marked cn13. [see page 8 for correct orientation] to store a number in a one button autodialler. Press the button on the front panel to go off hook. Press the key marked pg on the rear of the telephone ...
Setting up the 711 features. Volume. To adjust the volume of the speaker use the v+ and v- keys on the rear of the phone. The volume once set will remain at the user set level until it is re adjusted. Call termination settings. Call termination can be by pressing the off button on the front of the t...
Hf gain handset hksw hfbuts hfhls hflls load 1 2 line a er b + - power tmr type nrm mic enable disable hs loop lp gain keypad hk time dial break mf ld tbr er boot on hk r/p pg mr v+ v- m1 m2 m3 ra711 printed circuit board cn13 page 8 3 2 1 6 5 4 9 8 7 0 # *.
Setting up the expansion board. Overview. The dac dtmf controller expansion board product consists of a printed circuit board (pcb) which can be attached to the dac range of telephone products which feature an expansion port. The pcb provides a dtmf decoder and controller which allow a voltage free ...
*1*nn where nn represents the pin/command mode timeout value 01-99 seconds (10 seconds default) *2*nn where nn represents the voltage free contact energise time value 01-99 seconds (2 seconds default) *3*xxxxyyyy where xxxx is the current pin and yyyy is the new pin (xxxx = 1234 default) *4*n where ...
General care and maintenance the 711 telephone does not require any regular maintenance. To clean the telephone wipe with a damp cloth. Do not use any abrasive cleaners on the telephone as this may cause the product to become discoloured. Distributed by:- dac limited 28 lomeshaye business village tu...
