Dacor DHICH - Chimney Only Installation Instructions Manual - page 10
8
Install the Duct Work
wArning
Do not use screws to attach the duct work to the hood
exhaust outlet. Use duct tape only. Screws may prevent
the damper flaps on the top of the hood from opening.
Install the duct work system according to the specifica-
tions on pages 4 and 5. Lift the chimney up and reach
inside the framework to access the hood exhaust. Attach
the duct to the hood exhaust with duct tape alone. Use
sheet metal screws (not provided) and duct tape on all
the remaining duct system joints.
Hang the Hood
wArning
To prevent personal injury, do not rely on the
mounting springs to hold the hood assembly in place
on the ceiling. Once the hood is hooked in place
IMMEDIATELY secure the framework to the mounting
bracket as described below.
Before raising the hood into position, lift it up and ori-
1.
ent it so that the control panel faces the same direc-
tion as the front of the cooktop or range.
Lift the hood assembly up on both sides and slip the
2.
end of the framework over the mounting bracket.
Push up until all four mounting springs protrude out of
the mounting slots on the top of the framework.
Attach the framework to the mounting bracket imme-
3.
diately using four self-tapping screws.
Installation Instructions
Mounting
springs
Duct work through
ceiling connects to
exhaust outlet inside
framework