Dacor EDW24S Installation Instructions Manual - page 13
11
Installation Instructions
Finish the Electrical Connection
WARNING
Electric Shock Hazard - Make sure electrical power has
been turned off at the circuit breaker panel or fuse box.
Do not connect the dishwasher to the power supply until
the appliance is permanently grounded.
All wiring connections must be enclosed in the junction
box. This unit has copper lead wires.
Verify that the power is turned off at the source.
1.
Strip the necessary insulation off the wires in order to
2.
make a good connection.
Fit the strain relief onto the outer sheath of the wire.
3.
Fit the strain relief into the junction box hole and
4.
tighten.
Locate the white, black and green dishwasher wires
5.
with stripped ends. Use wire nuts to connect the
incoming ground wire to green, white to white and
black to black.
Install the junction box cover with the screw provided.
6.
Check to be sure that the wires are not pinched under
7.
the cover.
Ground
White
Black
Strain relief
Verifying Proper Operation
WARNING
To ensure a safe and proper installation, the following
•
checklist should be completed by the installer to
ensure that no part of the installation has been
overlooked and the unit is working properly.
Proper installation is the responsibility of the
•
homeowner. The importance of proper installation of
your Dacor dishwasher cannot be overemphasized.
Pre-verification Check List
Confirm that the main power supply (at the circuit
□
breaker panel or fuse box) is off.
Verify that the dishwasher is level by pulling the
□
lower rack half way out. Let go of the rack and make
sure it does not roll in or out. If it does, re-level the
dishwasher.
Double check the electrical wiring, water supply line
□
and drain hose. Verify that all wiring is secure. Make
sure there are no kinks in the electrical wiring, water
supply line and drain hose. Make sure they are not
pinched or in contact with door springs or any other
dishwasher components.
Make sure all packing materials have been removed
□
from inside the dishwasher.
Familiarize yourself with operation of the dishwasher by
□
reading the use and care manual.
Remove any protective film, if present, from the control
□
panel, door panel, etc.
Add two quarts of water to the bottom of the
□
dishwasher to lubricate the pump seal.
Turn on the water supply and check for plumbing leaks.
□
Tighten connections if necessary.
Replace the access cover (underneath the
□
dishwasher).
Verify the hot water temperature by turning on the
□
hot water faucet at the sink. The water going to the
dishwasher must be between 120ºF and 150ºF.
Continued...