1. DL manuals
  2. Dacor
  3. Ranges
  4. ER30DSRSCH
  5. Installation Instructions Manual

Dacor ER30DSRSCH Installation Instructions Manual

Other manuals for ER30DSRSCH: Installation Instructions, Use And Care Manual
Manual is about: Dacor Epicure ER30DSCH: User Guide

Summary of ER30DSRSCH

  • Page 1

    Installation instructions epicure ® range for use with models: er30d, er30d-c, er30dsr part no. 102187 rev. G this appliance has been tested in accordance with the latest edition of ansi z21.1 standard for household gas appliances..

  • Page 2

    © 2007 dacor, all rights reserved. All specifications subject to change without notice. Dacor ® assumes no liability for changes to specifications..

  • Page 3

    Important safety instructions ..................................................1-3 customer service information ....................................................3 planning the installation ...........................................................4-8 electrical requirements .......................

  • Page 4

    Important safety instructions warning read the accompanying use and care manual before operating this appliance. Keep packaging materials away from children. Plastic sheets and bags can cause suffocation. If you receive a damaged product, immediately contact your dealer or builder. Do not install or...

  • Page 5

    Model and serial number location serial number and rating labels located inside unit, behind grill. If you have questions or problems with installation, contact your dacor dealer or the dacor customer service team. For repairs to dacor appliances under warranty call the dacor distinctive service lin...

  • Page 6

    Planning the installation warning important: observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. Electrical requirements important: the information below applies only to free standing units equipped for use in t...

  • Page 7

    Product dimensions all tolerances: ±1/16” (±1.6 mm) unless otherwise stated planning the installation b e a c d gas inlet electrical connection hole in bottom back of range range electrical access, cover removed gas and electrical dimensions - all models gas - electrical access dimensions a b c d e ...

  • Page 8

    Planning the installation 1 9/16” (40mm) 23 1/8” (587mm) 23 5/8” (600mm) 26 11/16” (678mm) 35 3/4” (908mm) to 37 7/8” (962mm) 28 3/16” (716mm) 45 5/8” (1159mm) rear of front panel to back of chassis rear of front panel /oven door front panel front edge of bullnose front of handle front of open door ...

  • Page 9

    Planning the installation cutout dimensions f g 36” (914 mm)* 30” (762 mm)** 30 1 / 16 ” (764 mm)* * recommended ** minimum 2 1, 4 f g 2 cabinet/countertop depth is at discretion of customer but cabinet face must not protrude further than rear of front panel, see product dimensions. 3 consult local ...

  • Page 10

    Parts list 2 grates 1 small stack burner cap 1 small stack burner ring 2 large stack burner caps 2 large stack burner rings 1 crown burner cap 1 crown burner ring 1 crown burner head 1 gliderack™ oven rack 2 standard size racks • • • • • • • • • • 4 knobs anti-tip bracket w/screws meat probe griddle...

  • Page 11

    Installation instructions changing the backguard (models er30d and er30d-c) models er30d and er30d-c come standard with a 3” backguard installed. The 6” and 9” backguards are optional. To change the backguard: remove and retain the three (3) chrome screws on the front of the existing backguard. Remo...

  • Page 12

    0 close the door. Remove and retain the two screws from the back of the kick panel as shown below. Pull the kick panel free from the front of the unit. Remove the left end cap retaining screw from under the rim of the control panel and remove the end cap. Hold the left side panel in position on the ...

  • Page 13

    With the door closed, reattach the kick panel to the range by snapping the ball studs on the back of the panel into the holes on the front panel of the range. Open the door and reattach the kick panel top screws removed in step 1. Installing a raised vent (optional) install the erv30 or prv30 raised...

  • Page 14

    Installation instructions installation instructions removing the oven door warning do not attempt to disengage the hinge catches with the door removed from the oven. The hinge springs could release causing personal injury. Do not lift or carry the oven door by the door handle. • • to make the range ...

  • Page 15

    Installation instructions installation instructions connecting the wiring to the range refer to the range rating label (see page 3) for power requirements. There are four possible ways to wire the range: 4 wire conduit 3 wire conduit (where local codes permit) 4 wire appliance cord (where local code...

  • Page 16

    Electrical connection (cont.) connecting the conduit to the house electrical junction box warning do not ground the appliance to a gas supply pipe or hot water pipe. Do not turn on power to the appliance until the range is permanently grounded. A grounded cold water pipe must have metal continuity t...

  • Page 17

    Installation instructions connection to power supply connection to appliance (page 13) separate no. 10 (minimum copper grounding wire junction box fasten clamp tightly on pipe wire nut, 4 places 4 wire connection conduit junction box connection with external ground clamps metal water pipe no. 4 copp...

  • Page 18

    Installation instructions slide the end of the appliance cord into the strain relief from the bottom of the box connect the white (neutral) wire to the neutral terminal in the box. Connect the l1 wire to the l1 power supply terminal in the box. Connect the l2 wire to the l2 power supply terminal in ...

  • Page 19

    Installation instructions loop and spade terminal connections bare wire connections 4 wire appliance cord connection strain relief l2 wire white wire green wire neutral terminal l1 terminal l2 terminal jumper removed grounding screw l1 wire 14-50p plug neutral l2 l1 ground gas supply connection warn...

  • Page 20

    Installing the burner knobs caution installing the range knobs in the wrong position may result in damage to the griddle included with the range. The knobs for the right burners are marked with the maximum griddle settings. There are two (2) different types of knobs supplied with the range. The knob...

  • Page 21

    Installation instructions stack burner installation burner head crown burner stack burner spill tray burner ring ridge on bottom of burner cap step 1: put burner ring on top of head. Step 2: turn ring until it drops into place. Twist back and forth to assure proper seating. Step 3: install burner ca...

  • Page 22

    0 verifying proper operation prior to operating the cooktop or oven, please read the accompanying use and care manual completely. It contains important safety, service and warranty information. Before beginning the test procedure, ensure that all cooktop control valves are in the “ off ” position, a...

  • Page 24

    Dacor ● 1440 bridge gate drive, diamond bar, ca 91765 ● tel: (800) 793-0093 ● fax: (626) 403-3130 ● www.Dacor.Com.