Dacor Preference PGM304-1 Installation Instructions Manual - page 8
6
Verify Package Contents
Literature
•
Hold down brackets (2)
•
Cleaning kit (stainless steel models only)
•
Grates
•
Burner sets (4 for model PGM304-1, 5 for model
•
PGM365-1)
Gas pressure regulator
•
Installing the Cooktop
WARNING
Verify that the power supply meets the specifications
•
on page 3 before proceeding.
To prevent damage to the gas pressure regulator,
•
install it only after the cooktop is mounted in its per-
manent position.
IMPORTANT
Do not over-tighten the hold down bolts. Over tight-
•
ening the hold down bolts may result in improper
operation of the dual gas burners.
Do not use a hardening compound or caulk to perma-
•
nently seal the cooktop into place. The cooktop must
be readily removable if service is required. Removal
of sealant to service the unit will be performed at the
customer’s expense.
Lower the cooktop into the cutout and center it.
1.
Secure the cooktop to the countertop using the two (2)
2.
provided hold-down brackets as shown.
PGM Hold Down
Bracket Mounting Holes
(both sides)
Gas Inlet
Electric Cord
Installation Instructions
Hold Down
Bracket Installation
Connecting the Gas Line
WARNING
Verify that the gas supply meets specifications before
•
connection. See page 3.
Do not install or use the cooktop without the included
•
gas regulator installed.
Ensure that the arrow on the regulator points in the
•
direction of the gas flow, towards the cooktop.
Do not apply excessive pressure when tightening gas
•
connections and fittings.
Do not use Teflon tape or plumber’s putty on flexible
•
gas line connections.
Test the gas lines for leaks as instructed before use.
•
Do not use a flame to check for leaks.
The maximum gas supply pressure to the regulator
•
must never exceed ½ pounds per square inch (psi)
or 3.5 kPa.
The cooktop and shut-off valve must be disconnected
•
from the gas supply piping during any pressure test-
ing exceeding ½ psi (3.5 kPa).
For LP gas installations, the LP gas tank must have
•
its own high-pressure regulator in addition to the
pressure regulator supplied with the cooktop.
Attach the gas pressure regulator (included with the
1.
cooktop) to the cooktop pipe nipple inlet. For tight
installations, the regulator may be installed upstream
from the pipe nipple, anywhere between the shut-off
valve and the cooktop. For best performance, minimize
gas pressure loss by attaching the regulator as close
as possible to the cooktop gas inlet.
Complete connection of the gas supply to the cooktop
2.
by installing a minimum ½” flexible gas line (not includ-
ed) between the pressure regulator and the shut-off
valve.
Check for gas leaks:
3.
Turn all cooktop control valves to the
◊
OFF
position.
Turn on the gas supply valve and check all lines
◊
and connections for leaks using a soap and water
solution or a gas leak detector.
Turn the gas supply off.
◊