Dacor Preference PGM304-1 Installation Instructions Manual - page 9
7
Burner Cap
Burner Head
Base
Cross Ring
Skirt
Cap Cover
Wide Side
Down!
Insert Pin on Bottom
of Cross Ring into
Hole on Base
Put Hole in Bottom
of Burner Head Over Pin
on Top of Cross Ring
PGM Burner Components
Burner Head
Grate
Cap Cover
Line Up Notch
on Bottom of
Head with Igniter
Single Burner Assembly
Dual Burner Assembly
Installation Instructions
Installing the Burner Components
WARNING
Never attempt to operate the cooktop with any of the
•
burner parts removed.
Do not attempt to adjust the burner air mixture set-
•
tings. All adjustments are preset at the factory.
Remove the burner heads, burner rings, burner caps
1.
and grates from their shipping packages.
Install the burners as shown. When installing the burn-
2.
er components, twist each piece back and forth until it
drops completely into place. The burners will not oper-
ate properly unless all of the burner pieces are properly
seated.
Gently set the grates on top of the spill tray. Make
3.
sure that the rubber feet are positioned in the locating
dimples.