Daewoo 15U7LT Instruction Manual - page 14
13
SUBPAGE ( ) button (A6):
- Press the SUBPAGE button (A6). In the extreme top left corner, instead of
the page number, ‘’S. . . .’’ will be displayed. This is ready to accept the sub-
page number.
- Enter directly the subpage number you want with the remote control
NUMBER 0..9 buttons (A2): for example to request the 2nd subpage, type
0002.
- After a few seconds the subpage number is replaced by the page number
in the header. You can press again SUBPAGE button (A6), to display the
subpage number.
- If the requested page is not immedietly available the rolling header will be
active until the page arrives.
Warning: If the subpage is not available (does not exist), then the header
will roll continuously and no new page will be found.
Note: Teletext specification allows for subpage numbers 0000 to 3979
(the first figure is limited to the range 0..3, and the third figure 0..7).
REVEAL ( ) button (A11):
Press this button to reveal, on certain pages, hidden information such as the
answer to a quiz.
- Press the button again to hide the information.
TELETEXT FORMAT PICTURE & SOUND CONTROL
Doubling character height
Repeatedly pressing the HEIGHT ( ) button (A12) doubles the character
height in the following order:
Upper half of the page (UP)
Lower half of the page (DOWN)
Return to
normal height.
If the page is in UP or DOWN mode, then normal size is automatically set if :
- A new page request is made (e.g. CYAN, INDEX or PAGE UP/DOWN).
- CANCEL mode (A13) function is used.
- VOLUME menu is activated the with the MENU button (A7).
Note : The menu at the base of the screen is always visible
Volume and brightness control in teletext mode
VOLUME (and sound MUTE), BRIGHTNESS controls are all possible in tele-
text. The BRIGHTNESS control are dedicated to the teletext display.
- Access the VOLUME control by pressing the MENU button (A7) in teletext
mode. A barograph will appear in the lower part of the screen (as in TV
mode). If MUTE is active a mute icon is also shown.
- A second press on the MENU button (A7) will access the BRIGHTNESS con-
trol.
- The active bargraph will timeout after 3-4 seconds (as in TV mode VOL-
UME control) or by pressing on the MENU button (A7) a third time after
brightness control
- Each control can be adjusted by using the remote control CURSOR RIGHT
(A6) / LEFT (A9) buttons.
- Mute can always be activated by pressing the SOUND MUTE button (A10).
- Any change to the VOLUME level will cancel the SOUND MUTE.