Daewoo DSA-101L Service manual - Indoor Unit

46

1

INDOOR UNIT

10. DISASSEMBLY INSTRUCTIONS

PROCEDURES PHOTOS 

1. Stop the Air conditioner and disconnect the power cord from the wall 

outlet.

2. Removing the Insert Grille and Frame Grille. (Fig 1~2)

!

Draw up the Insert Grille and remove it.

@

Loosen two special screw for fixing the Cover Ter-Block.

#

Loosen three screw at the Body.

$

Remove the Frame Grille.

3. Removing the Control Box. (Fig 3)

!

Remove room and coil thermistors.

@

Disconnect the fan motor lead wire from connection  at the 

Control PCB.

#

Disconnect the stepping motor lead wire from connection at the 

Control PCB.

$

Remove the select switch from connection at the Control PCB.

%

Loosen a screw for fixing ground wire.

^

Remove the Control Box

4. Removing the Drain Pan. (Fig 4)

!

Disconnect the Body drain hole. (left and right Body)

@

Disconnect three hook and remove the Drain Pan.

5. Removing the Indoor  Evaporator. (Fig 5~6)

!

Remove three screw for fixing indoor  Evaporator at the Body.

@

Remove the hook for fixing Bracket Pipe at the back of Body.

#

Remove Indoor  Evaporator.

6. Removing the Cross Flow Fan. (Fig 7)

!

Remove set screw for fixing Motor shaft.

@

Remove Cross Flow Fan.

7. Remove Motor IDU and Bearing Plastic.

Fig 2

Fig 1

Fig 3

Fig 4

Fig 5

Fig 6

¡

DSA-101L/DSA-121L

Fig 7