Daewoo DSJ-4710CRU Service Manual - page 11
10
Adjusting Method
Step 8. Control of white balance
1) Connect a control pattern (intra-office signal cable broadcasting 32 CH) with external input 3.
2) Select the screen mode as standard.
3) Locate the sensor of 3298 system at the center of High/Low Beam.
4) Execute the projection program of control PC.
5) When OSD of ‘OK’ appears on the monitor of control PC, the control is completed.
Measuring unit: Multimedia Display Tester 3298(YOKOGAYA)
Measuring signal: White -Balance Control Pattern (Intra-office signal cable broadcasting
32CH)
Coordinates setup:x=0.288
0.005 / y=0.301
0.005
Initial data (S8)
R DRV : 32 (RED DRIVE)
G DRV : 32 (GREEN DRIVE)
B DRV : 32 (BLUE DRIVE)
SUB BRIGHTNESS :32
SUB CONTRAST : 0
R CUT : 32 (RED BIAS)
G CUT : 32 (GREEN BIAS)
B CUT : 32 (BLUE BIAS)
Applied chassis and model:SJ-113/DSJ-4710(20)