Daewoo DWA-182RH User Manual - page 10
9
FUNCTION
ON TIMER
Push the ‘TIMER/CANCEL’
button when unit is off.
(REMOCON ONLY)
SLEEP MODE
Push the ‘SLEEP’ button in
‘COOLING’ mode and
HEATING MODE. (REMOCON
ONLY)
Defrost the heat-exchanger of
the outside (in heating mode)
OPERATION
1. Timer is changed to as follows by
pushing “TIMER/CANCEL” button.
(1hr
→
2hr
→
3hr
→
4hr
→
5hr
→
6hr
→
8hr
→
10hr
→
12hr
→
16hr
→
20hr
→
24hr
→
cancel)
2. The unit starts working after set time
is over. (by the operation mode and
last setting temperature before the
unit is off.)
3. If you want to cancel timer, push this
button again at any time.
1. SLEEP MODE is changed as
follows by pushing “SLEEP” button.
(LP
→
Cancel)
* LP Mode
– The unit is off after 4 hours.
– The desired Temp is increased
3°C (5.4°F) for 4 hours in Cooling
mode.
– The desired temp is decreased
3°C (5.4°F) for 4 hours in heating
mode.
– Auto swing is selected.
– Fan speed is set to ‘LOW’.
2. Set proper desired room
temperature, fan speed and auto-
swing mode.
3. This mode can be selected in
‘COOLING’ and ‘HEATING’ mode
only.
The unit runs 50 minutes
The unit will start defrost function when
the temperature of the heat exchanger
of the outside arrived at the programed
temperature.
If not arrived at the programed
temperature, the unit continuousiy runs
the heating mode.
While the defrost function is working
the unit runs cooling cycle but the fan
stops.
DISPLAY
1. ‘TIMER’ lamp lights.
2. Setting time is displayed.
3. After a few seconds, display is
changed to current room
temperature. and ‘ROOM TEMP’
lamp lights.
1. ‘LP’ is displayed.
2. ‘ROOM TEMP’ and ‘DESIRED
TEMP’ lamp is off.
no display
FAN
HEATING
COOLING
ROOM TEMP
DESIRED TEMP
TIMER
TIMER/
CANCEL
SLEEP
• ROOM TEMPERATURE DISPLAY.
Over 45°C or 100°F
5°C~45°C or 41°F~99°F
Below 5°C (41°F)
DISPLAY TEMPERATURE