E-Collar Einstein ET-1202TS Owner's Manual - How to Change Boosting Level
16
Einstein Owner's Manual 802TS / 1202TS
How to Change Boosting Level
- Einstein provides Boosting Stimulation Function for the emergenc
ies.
- Default boosting level is 20
, it can be easily changed by following the
procedure given below.
BUTTON FUNCTIONS
* Dog 1
1. Change the mode to Momentary Mode (Press M/C button until “M” is displayed)
.
2. Change the intensity level to “0”
.
3. Press S
(1D)
button for more than 5
sec to enter into Booster
Level Change Mode for
Dog 1. The intensity level “0” will start to blink.
4. Rotate the dial to change the boost
ed
level. (The range of
available levels
is from
1 to 60)
Use 1 to 20 for small breeds and 20 to 40 larger more stubborn breeds.
5. Press
S(
1D
) button again to save
the new
level and exit from Booster Level Change
Mode.
6. If
no
button is pressed or 20 seconds passes, Booster Level Change Mode will be
cancelled.
* Dog 2
1. Change the mode to Momentary Mode (Press M/C button until “M” is displayed)
2. Change the intensity level to “0”
.
3. Press
S
(2D)
button for more than 5 sec and enter into the Booster Level Change Mode
for Dog 2. The
intensity level “0” will start
to blink.
4. Rotate the dial to change the
boosted
level. (The range
of available
level is from 1 to
60) Use 1 to 20
for small breeds and 20 to 40 larger more stubborn breeds.
5. Press
S
(2D)
button again to save new level and exit from Booster Level Change
Mode.
6.
If no button
is pressed or 20 seconds passes, Booster Level Change Mode will be
cancelled.
Back to Factory Default Setting
Your e-collar transmitter is a small computer, if you feel it is behaving
badly, it probably needs to be reset. Please turn the stimulation to “0”
and press both stimulation buttons and the mode button at the same
time for 2 seconds. The mode and boost level will revert back to the
default settings.