E-Collar Technologies Barkless Pro BP-504 Owner's Manual - page 2
COMPONENTS
• BP-504 Collar Unit with collar strap
• Lithium Polymer Charger Adapter
• Stainless Steel Contact Points
• Contact Point Removal Tool
• Sensor Post for Long Contact Points
GETTING STARTED
TURNING THE COLLAR ON / OFF
To turn on the BP-504, simply press the Control Button for 0.25 seconds, a
beep will sound and the Bark Count Mode will be displayed.
To turn off the BP-504, simply press and hold the Control Button for 5
seconds, a beep will sound and the Software Version will be displayed.
CHARGING THE BP-504 UNIT
Indicator light will turn Solid Red during charge cycles and will turn Solid Green
once it is fully charged. ( approximately 2 hours )
NOTE
Indicator light will flash GREEN under normal operation
Indicator light will turn solid RED when stimulation is applied.
Blinking RED when recharging is required.
PROGRAMMING MODE
The BP-504 features 5 programming modes. The initial mode is the bark
counter, pressing the Control Button will toggle through the modes as shown in
the diagram.