E-FLITE Blade MCX S300 Instruction Manual - page 4
6
7
6
7
Additional Equipment
No additional equipment is required to complete your Blade mCX S300.
Preparing for the First Flight Checklist
Please note this checklist is not intended to be a replacement for the content
included in this instruction manual. Although it can be used as a quick start guide,
we strongly suggest reading through this manual completely before proceeding.
•Removeandinspectcontents
•InstallfouroftheincludedAAbatteriesinthecharger
•Beginchargingtheflightbattery
•InstalltheremainingfourAAbatteriesinthetransmitter
•Installtheflightbatteryinthehelicopter(onceithasbeenfullycharged)
•Testthecontrols
•Familiarizeyourselfwiththecontrols
•Findasuitableareaforflying
Flying Checklist
Please note this checklist is not intended to be a replacement for the content
included in this instruction manual. Although it can be used as a quick start guide,
we strongly suggest reading through this manual completely before proceeding.
•Alwaysturnthetransmitteronfirst
•Plugtheflightbatteryintotheleadfromthe5-in-1controlunit
•Allowthe5-in-1controlunittoinitializeandarmproperly
•Flythemodel
•Landthemodel
•Unplugtheflightbatteryfromthe5-in-1controlunit
•Alwaysturnthetransmitterofflast
Battery Warnings and Guidelines
While the 1S 3.7V DC Lithium Polymer Battery Charger (EFLC1103)
included with your Blade mCX S300 has been specifically designed to
safely charge the included 1S 3.7V 110mAh Lithium Polymer Battery
(EFLB1101S), you MUST read the following safety instructions and warnings
before handling, charging or using the Li-Po battery.
Note: Lithium Polymer batteries are significantly more
volatile than the alkaline, Ni-Cd or Ni-MH batteries used in RC
applications. All instructions and warnings must be followed
exactly. Mishandling of Li-Po batteries can result in fire.
By handling, charging or using the included Li-Po battery you assume
all risks associated with lithium batteries. If you do not agree with these
conditions, return your complete Blade mCX S300 model in new, unused
condition to the place of purchase immediately.
•Youmustchargetheincluded1S3.7V110mAhLi-Pobatteryinasafeareaaway
from flammable materials.
•Neverchargethebatteryunattended.Whenchargingthebatteryyoushouldalways
remain in constant observation to monitor the charging process and react to
potential problems that may occur.
•Afterflight,thebatterymustbecooledtoambienttemperaturebeforecharging.
• You MUST use the included 1S 3.7V DC Li-Po Charger (EFLC1003) ONLY.
Failure to do so may result in a fire causing personal injury and/or
property damage. DO NOT use a Ni-Cd or Ni-MH charger.
• If at any time during the charge or discharge process the battery begins
to balloon or swell, discontinue charging or discharging immediately.
Quickly and safely disconnect the battery, then place it in a safe, open
area away from flammable materials to observe it for at least 15 minutes.
Continuing to charge or discharge a battery that has begun to balloon or
swell can result in a fire. A battery that has ballooned or swollen even a
small amount must be removed from service completely.