E-FLITE The Beast Instruction Manual - page 10
10
EN
Service of Power Components
Disassembly
Propeller
•Removebatteryhatchbyslidingitforward,
then up and away from the fuselage.
•Removescrew,spinner,propellerandback-
plate from the motor shaft. Figure A.
•Carefullyremovespinnerfrompropellerand
backplate. Figure B.
Note: Since the propeller and spinner are
glued together, glue residue will need to be
cleaned from the spinner or propeller when
these parts are used again.
Motor and Firewall
•Remove2screws,firewallandmotorfromthe
fuselage motor mount. Figures E, F and G.
Note: The motor magnet will attract screws to
the motor.
•Removetopscrewfromthefirewallandmotor.
Figure H.
• DisconnectmotorwireconnectorfromESC/
receiver connector. Figure I.
Assembly
Motor and Firewall
•ConnectmotorwireconnectortotheESC/
receiver connector so wire colors align.
Figure I.
•Installmotorinfirewallusingascrewputin
the top of the firewall. Figure H.
•Attachfirewalltofuselagemotormountusing
2 screws. Figure E.
Propeller
•Assemblebackplate,propellerandspinnerus-
ing foam-safe CA. Align then glue spinner over
propeller and backplate.
Figures A, B and C.
Note: Numbers on the propeller must face out
from fuselage for correct propeller operation.
Figures C and D.
•Installassembledbackplate,propellerand
spinner on motor shaft using a screw.
Figure A.
•Putfoambatteryhatchonthefuselageand
slide it back to fully engage the fuselage.
•Ifneeded,keepthewheelpantsfromturningonthelandinggearbyputtingasmall
amount of foam-safe CA glue on the end of the landing gear wire.
•Whenthefuselagemustbeopenedforaccesstoservosorreceiver,cuttapeordecals
to open the canopy hatch.
Note: Removing tape or decals will remove paint from the fuselage.
CAUTION: DO NOT handle propeller parts while the flight battery is connected.
Personal injury could result.