E-Joe EPIK SE 2017 User Manual - page 10
Bicycle Battery Charger and Charge Indicator Lights
To see the battery levels, use the charge indicator on the Electric Assist LED Display located on the left handlebar.
The battery charger for the Epik SE is equipped with an LED light indicator that works to help you preserve the battery life of your
bicycle by allowing you to see if your Epik SE is completely charged.
●
Red = Charging
●
Green = Fully Charged
Battery Precautions:
●
Do not touch the two poles of the battery with your hands when the battery is removed for charging. The two battery
poles should not be touched with any other metal or other material that conducts electricity.
●
While charging, put the battery in a secure place where children cannot reach it.
●
Do not use any other charger other than the one that came with your electric bike. If you need another charger, contact
your local dealer or e-JOE Bicycle.
●
Do not attempt to open or repair your charger, the electronics contain high-pressure circuits, so do not dismantle by
yourself without a professional.
●
Avoid any contact with water while charging; prevent liquids, metal, and metal fillings from permeating the charger, and
be careful to not drop or hit the charger, which could damage its components.
●
So not put anything on top of the charger while charging; it must be well ventilated to allow the heat that is generated to
dissipate.
●
Stop charging the battery immediately if you notice a peculiar smell or the charger gets too hot to touch.
●
To prevent premature failure of your battery and for you warranty to remain in effect on your battery, it is
RECOMMENDED to charge and discharge your battery at least once per month. Do NOT use your battery in a very low
state.
●
To preserve the life of your battery, it is RECOMMENDED that you do not leave your battery charging for periods longer
than 48 hours.
●
It is normal that the distance range will reduce as a result of low temperatures.