E Star MID7114 User Manual - page 8
8
Click the main interface shortcut, select “Internet connects manager”, click “WIFI setting”, enter WIFI
setting interface, select the “WI-FI” and turns it on.
After WIFI opened, it will automatically search for the wireless Internet, and show in the list, click the
wireless Internet, enter the password interface, input the password and connect it, seconds later it will connect
to the wireless Internet automatically.
When open the WIFI, it will add about 1/4 power consumption to the palyer. When not using the WIFI,
please turn it off to extend the using time of the player.
4-2. 3G Connection
a. External USB dongle 3G card
First, connect USB 3G card to the product through OTG-USB cable. One moment later, the system will
detect this device and automatically switch the mode. After successful switch, enter “Setting / Wi-Fi and
Network”, select “Mobile Network” and the system will connect to the network automatically. Connection
completed, you can use 3G.
Before connecting 3G, please close Wi-Fi.
Before connecting 3G, please make sure the product is with enough power or connected to DC charger
charging. Since 3G will consume more power (add about 1/3 more), If you don't use 3G, unplug the dongle to
save power to extend battery life.
4-3. Ethernet Setting:
Use cable Ethernet card (USB-RJ45) connecting to Internet instruction
There are two requirements as below to use USB-RJ45 connecting to Internet:
1. ADSL aacount and password are set up correctly on router.
2. USB-RJ45 network card is the model which this device can support (usually netcard which supports
Android system is suitable for this device).
Models supported are listed below:
AX88772/AX88772a/AX88772B/AX88178/AX88760/QF9700/SR9600/MCS7830/MCS7832/MCS7730
Steps for Internet Connection:
First connect network cable to USB Ethernet card, then use the OTG cable which is for this device to
insert into USB Ethernet card and the other end into USB port of this device.
Notes:
1. First close WIFI network, only one could be used, otherwise there
will be conflict.
2. This device will automatically detect USB Ethernet card and switch
on the “Ethernet”, there will be a network icon in the status column at this
time.
3.Hold on for moment, this device will try to connect to Internet
automatically, if the router, the DHCP service is already open and the
netgate, DNS and relevant setting have
been made, then it will connect to Internet automatically.(Ethernet card function must be selected already)
4. If this device fails to connect, usually the reason is something is wrong with setting in router. You can
set the parameters in this device as follows:
a. Enter setting/Eterhnet setting, select and open Ethernet.
Enter configuration information, choose “static IP setting, enter static IP setting interface (default is
automatic aquiring IP, usually automatic aquiring IP is OK for all, but some companies’router will use
specified IP, not allowing aotomatic aquiring IP, it depends on router setting, static IP needs to be used at this