E-Tech ET8 User Manual - page 5
E-TECH ET8 V4 CONTROL PANEL - USER MANUAL
5
INTRODUCTION
The E-Tech ET8 micro computer based 8 zone
control panel is the heart of your security
system to which all your detection devices
connect.
Each Zone of the panel can be connected to
one or more detection devices to protect
separate rooms of your premises.
Detection devices may be connected to the
ET8 control system directly by cabling or with
optional wireless (Radio) devices.
Detection devices called Passive Infra-Red
Detectors (or P.I.R’s for short) can detect the
movement of an intruder by sensing their body
heat. P.I.R’s are used to cover various critical
areas of your premises where an intruder may
enter or trespass. Another detection device used
is called a Reed Switch. Reed Switches are
attached to windows and doors to detect if a
window or door has been opened. A Reed
Switch consists of a magnet which is normally
attached to the moving part of a window or door
and the Reed switch which mounts to the door
or window frame.
The panel is “Armed” when it is set to detect an
intruder. At other times it is “Disarmed”.
Normally a zone is considered Sealed.
Activation of a detection device will cause the
zone to be Unsealed and may cause an alarm.
Detectors such as fire detectors and panic
buttons must be able to generate an alarm at all
times regardless of the panel setting. A zone
with this assignment is called a 24 hour zone.
Some detection devices may be required to
generate an alarm or warning only when the
panel is Disarmed. A zone with this assignment
is called a Day zone.
Before leaving the premises you must Arm the
panel to enable it to detect intruders and
generate an alarm. After arming, the panel will
ignore detectors during the Exit Delay Time to
enable you to depart without triggering an alarm.
Arming the system may be done through the
keypad or with the use of optional Radio Keys
for Arming by remote control from outside the
premises.
When you enter the premises the panel will
ignore selected zones for the Entry Delay Time
and will not alarm unless you don’t Disarm the
panel during this allowed time.
Disarming the system may be done by keypad
or with the use of optional Radio Keys.
Monitor mode allows you to Arm selected zones
while others are ignored. Typically, perimeter
zones (doors and windows) can be monitored
while you are at home.
If you wish to split your alarm system into two
areas with access limited to each area by code
numbers then Area operation is used. Radio
Keys can also Arm and Disarm Areas.
The control panel housing and the covers over
external sirens are protected by tamper
switches to detect someone attempting to
disable the security system. Activation of these
switches will cause an instant tamper alarm.
If a detector becomes faulty, you can Exclude
the associated zone so that it is totally ignored
and cannot generate an alarm. Including the
zone will enable it to generate an alarm again.
The control panel is fitted with a rechargeable
stand-by battery to ensure your security system
continues to operate if the mains power is
interrupted. This control panel automatically
tests the battery every hour and whenever you
Arm/Disarm the panel. (Dynamic Battery test).
Whenever an alarm occurs, it may be silenced
with a User Code or by optional Radio Keys,
otherwise it will reset at the end of Alarm Reset
Time.
All alarms are stored in memory and may be
viewed at any time by entering Memory Mode.