E2v N6081 series Operation Manual

Manual is about: Stellar

Summary of N6081 series

  • Page 1

    N6081 series operation manual.

  • Page 3

    E2v technologies n6081 series operation manual # e2v technologies 2004 hbn6081-1 issue 5, january 2004 186/3591.

  • Page 4

    Safety notes the following warnings and precautions are for your safety and the prevention of injury. Read them carefully and observe at all times when installing or operating the n6081. Hazard warning signs, as defined in bs5378 safety signs and colours are used on the equipment to highlight any po...

  • Page 5

    Standards compliance this control unit complies with the following require- ments. Further details may be provided if necessary. * eec directive 89/336/eec electromagnetic com- patibility. * eec directive 93/97/eec satellite earth station equipment. * eec directive 73/23/eec low voltage directive e2...

  • Page 6

    Contents page 1 thank you for buying stellar . . . . . . . . . . . . . . . . . . . . . . . . 5 2 care of the control unit . . . . . . . . . . . . . . . . . . . . . . . . . . 5 2.1 storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 2.2 handling . . . . . . . . . . . . . . . . . ....

  • Page 7

    1 thank you for buying stellar thank you for buying this stellar product. This e2v technologies control unit allows the remote control of one stellar amplifier. Before using your new control unit, we recommend that you spend a little time reading this manual to familiarise yourself with its operatio...

  • Page 8

    3 installation considerations 3.1 mounting the control unit is designed to be installed in a standard 19-inch rack mount system and should be mounted and operated in the normal horizontal orientation. Fixing holes of the standard pattern are provided on the 1u front panel; these provide adequate sup...

  • Page 9

    The display will then show the following: 4.3 warm-up press the stby or xmit key whilst in the "off" state to begin the twt cathode warm-up process (180 seconds). In this state power is only applied to the twt cathode heater. "off" led will have gone out. Warm-up led will be lit. Display remains unc...

  • Page 10

    5 measurement and monitor functions 5.1 power (watts) once the n6081 has found an amplifier, its display will show the amplifier’s forward power in watts. 5.2 power (dbw) this feature can be selected by pressing the function select key once. This will display the amplifier’s forward power in dbw (de...

  • Page 11

    7 amplifier interface 7.1 introduction connection to the stellar amplifier is made via a 15- way d-type socket for the n6081x series or a 26-way d-type plug for the n6081x-01 series. The control unit obtains its power supply (15 v, 100 ma) from the stellar amplifier via this d-type connection. The d...

  • Page 12

    8 fault finding if the control unit does not work correctly, consult the following table before contacting either the stellar 24- hour hotline (see ‘customer care’, page 3) or your distributor for further assistance. Consult the relevant amplifier operations manual for descriptions of amplifier faul...

  • Page 13

    120r 1 / 4 w 120r 1 / 4 w 120r 1 / 4 w appendix a 41-way stellar 15-way d-type amplifier connector controller connector a 2 b 4 c 3 d 5 e 6 h 14 j 7 k 8 l 9 p r u 1 b 10 c twisted pairs 11 d 13 e 12 p.

  • Page 14

    To n631x 41-way control connector a b c d e p j k l u b c d e p r h g off s/o warm up s/o standby s/o transmit s/o sum. Fault s/o 0 v (b) off c/i standby c/i transmit c/i +15 v (aux) tx+ tx 7 rx+ rx 7 sg interlock i/p inv rf inhibit rf inhibit 26-way high density d plug (pl1) 8 6 7 5 4 19 2 25 9 24 ...

  • Page 15

    E2v technologies limited, 106 waterhouse lane, chelmsford, essex cm1 2qu, uk. Tel. Or fax: +44 (0) 1245 355398 stellar hotline fault report form date: call time: tel. No.: name: fax no.: organisation: location: country: product type: serial no.: category: a. 1 hour b. Next day c. Next working day na...

  • Page 17

    E2v technologies uk: e2v technologies limited waterhouse lane chelmsford essex cm1 2qu telephone: +44 (0)1245 493493 facsimile: +44 (0) 1245 492492 france: e2v technologies sas bat. 16 burospace f-91572 bie ` vres cedex telephone: (331) 6019 5500 facsimile: (331) 6019 5529 usa: e2v technologies inc....