Eagle 1241 Installation Instructions Manual - page 4
Page 4
2. A Touch-Tone
phone in parallel with the receiver line if used in the line hold mode.
3.0 CONFIGURING THE MODULE.
3.1 OPTION SWITCH DESCRIPTION.
The Eagle Model 1241 has many modes of operation. It can be custom configured for each installation. The
following is a description of each of the option setting switches. Recommended settings are italicized.
SW1:
ON = Factory test / Demo Mode.
OFF = Normal operating mode.
This switch is only used to facilitate demonstration of the system to prospecting users. If using the full time call back
mode, moving this switch to the ON position (DEMO Mode) changes the number of rings before activation from six or
ten (selected by SW2) to just one (1) ring. The duration of the demo mode is set with SW2.
For normal operation, place SW1 is OFF .
________________________________________________________________
SW2 is dependent upon SW1 for its operation.
If SW1 is in the NORMAL MODE (OFF) and SW4 is ON then:
SW2:
ON = 6 rings before answering.
OFF = 10 rings before answering.
If SW1 is in the NORMAL MODE (OFF) and ring detect is OFF (SW4 is OFF) then the operation of the Model 1241 is
independent of SW2's setting.
If SW1 is in the DEMO MODE (ON) then:
SW2:
ON = Fast time-out of the shut down timer. Shuts down in one minute instead of five minutes.
OFF = Normal time-out of the shut down timer. Shuts down in five minutes.
There is no recommended setting for SW2.
_________________________________________________________________
SW3:
ON = Activate in the "Two Way VOX mode" (automatic operation).
OFF = Activate in "Listen Only" mode (manual operation).
When the system is triggered by the trigger input or the ring detector, this switch controls how the Two Way audio will
activate. In some commercial applications where the possibility of a "hold up in progress" may occur, it is desirable
to have the system activate first in the "Listen Only" mode which will prevent the speaker from emitting any sound
when the system activates. If desired, the operator can then switch the audio to Two Way VOX after activation.
NOTE: When changing the Option Switches, always remove power, set switches, then
reconnect power. This insures that the new options will be read by the
microprocessor!
NOTE: When using the central station controlled relay connected to P8, SW1 must be in the
OFF position.
NOTE: It is recommended to have the module activate in the “listen-only” mode. Confirm
with local law enforcement if this is permitted.