Eagle Power IDROLAVA Parts & Operation Manual - page 9
Injection - Extraction Washing
1. Remove cartridge filter L and
retainer Z from vacuum head.
2. Remove air purifier and
Idro unit from the tank.
3. Pour cleaning solution and
water into the solution tank.
4. Insert the solution tank into
the recovery tank.
5. Attach the vacuum head onto
the tank by guiding the solution
hose Y into the solution tank,
Clamp the vacuum head to the
tank.
6. Connect vacuum hose to the
tank.
7. Connect the solution hose to
the power head by simply
inserting the male hose end
fitting into female fitting until it
locks. To remove, press red
button to unlock and pull apart.
8. Connect trigger gun to the
solution hose.
9. Attach appropriate accessory:
- Wand and carpet tool for
carpets. See Extraction Wand
Assembly, page 9.
- Wand, carpet tool and
squeegee brush shoe for hard
floors. See Extraction Wand
Assembly, page 9.
- Upholstery tool for upholstery
10. Turn the vac speed control
knob located on top of the
vacuum head to the shampoo
setting.
11.Press the green switch to
activate the solution pump.
Press the red switch to activate
the vacuum motor.
12.To clean, press trigger to
inject cleaning solution, press
tool down firmly and pull towards
you.
Y
Page 7