Eagle Power TKS510ET Operation & Maintenance Manual - Tks510Et Silver Series
TKS510ET SILVER SERIES
OPERATION AND MAINTENANCE
Page 3
2.1.2 - Mounting the handlebar
(Version with motor - Version with engine)
- Loosen the handlebar fixing screws.
- Position the handlebar in work position.
- Tighten the handlebar fixing screws.
In the case in which one of the above mentioned parts is missing, place
inform your dealer straight away.
Take care to keep the packaging materials (bags, cartons,
pallets, hooks, etc) out of the reach of children.
For security reason during the transport, the ignition keys
as been fixed to the handle.
1.6 - CONSOMABLES
Gear motor:
MOVIBLAK 300 lithium grease with
similar features.
Battery:
Distilled water.
Engine:
UNLEADED gasoline. Motor oil.
2.1 - PREPARING THE MACHINE FOR
OPERATION
(Version with motor - Version with engine)
2.1.1 - Mounting the side brush
(Version with motor - Version with engine)
- Switch the brush lift lever pos. 1 Fig. 3, to OFF.
- Remove the screw from the side brush drive shaft.
- Fit the brush on the shaft.
- Screw on the screw and washer.
Fig. 2/B
Fig. 2/A
1.2 - SERIAL NUMBER AND CE MARKING
Always ensure that the machine is provided with a name plate giving
the serial number and CE marking in the position shown in Fig. 1.
On the contrary advise your dealer immediatly.
1.3 - FOREWORD
The purpose of this manual is to inform the operator of the basic rules,
safety rules and criteria which must be observed when using,adjusting
and maintaining the machine. The machine has been developed and
has been developed and manufactured to ensure an excellent perform-
ance and the utmost comfort and ease of operation in a variety of
working conditions. Before delivery, the machine has been checked
at our factory and by our dealer to make sure it is handed over to you
in perfect working order. To maintain the machine in this condition
and ensure problem free operation, it is essential to follow the routine
maintenance instructions given in this handbook.
1.4 - UTILIZATION FIELD
The machine, composed of a brush and a suction system, is to be used
EXCLUSIVELY to clean dry surfaces. Any other use could be cause
of damage to people or things and is therefore PROHIBITED.
1.5 - UNPACKING THE MACHINE
Unpack the machine with the utmost care;avoid carrying out any
operation that could damage it. Once it has been unpacked,check
whether it is damaged. If you notice that it is not in correct working
order, DO NOT use it and inform your dealer.
For packaging and transport purposes,some parts and accessories are
supplied disconnected from the machine. To assemble them,carefully
follow the instructions given in the relevant sections.
Contents of package:
N° 1
Machine.
N° 1
Side brush.
N° 1
Instructions and spareparts manual.
N° 2
Ignition keys.
N° 1
Declaration of conformity.
N° 1
Warranty slip.
Serial number
Fig. 1