EandCPower Renata - I Series User Manual - page 10
Page 9
1. Bypass On (Green).
2. Load on Bypass (Yellow).
3. Mains ON (Green).
4. Load On Battery (Yellow).
5. Load On Inverter (Green).
6. Output ON (Green).
7. Input fault (Red).
8. Battery Low (Red).
9. Inverter Fault (Red).
10. Over Load.(Red).
11-15. Battery Levels LED Indicators.
16 – 20 Load Levels LED Indicators.
21. Display.
Control Switches:
1. SW1 - Inverter OFF Switch (Red).
Turn OFF the Inverter, When press SW1(red) for 5 Sec, the unit will
turn off the inverter and unit transfer from normal operation to
Bypass mode.
2. SW2 - DPM Scroll (Blue).
3. SW3 - Inverter ON Switch (Green).
Turn ON the Inverter, When press SW3 (Green) , the unit will turn
ON the inverter and unit transfer from Bypass to Normal operation..
Power Switch
Located at the rear panel of the unit controls the input AC power and
Input batteries power for the unit.
3.3.3. Power ON Procedure:
The procedure is very simple. Please follow the steps for bellow operations.
Start Up.
a) Make sure that the power switch is OFF and there is no equipment
connected to the unit.
b) Check for correct input voltage.
c) Power ON the unit and the LINE, BYPASS, Load ON Bypass
and Output
indicator will be ON. The cooling fans will also be running.
d) In about 20 seconds, the Bypass Indicator will be OFF while the Inverter will
be On indicating every thing is normal.
Renata I - Series User Manual