Thank you for purchasing an earlex electric airless spray gun. Please read all these instructions before operating this product and retain them for future reference. Earlex ltd will accept no responsibility for the use of this product if used for any other purposes than those detailed herein. Model ...
Keep work area clean - cluttered areas and benches invite injuries. Consider work area environment - do not expose the spray gun to rain. Do not use the spray gun in damp or wet locations. Keep work area well lit. Guard against electric shock - avoid body contact with earthed or grounded surfaces (e...
1. 1.0mm nozzle sg209 2. 0.6mm nozzle sg211 3. Piston spring 55w sg234 4. Piston assembly sg237 5. Suction tube and filter assembly sg240 6. 1.0 litre paint container sg242 7. Valve assembly - pack of 3 sg310 8. Viscosity cup sg243 9. Lubricating oil sg244 6 8 3 7 * circled numbers need to be cleane...
To obtain the best results from your spray gun read these instructions carefully before use. The spray gun can be used to spray many different materials including varnishes, wood preservatives, enamel paints, oil based paints and water based paints. The spray gun can be used for a variety of applica...
5 preparation of the surface and thinning of the paint are the two most important areas to be concerned with to obtain the best results from your spray gun. Ensure all surfaces are free from dust, dirt, rust and grease. If necessary rub down with sandpaper, or similar. Mask areas you do not wish to ...
6 safety warning! Do not spray flammable materials (flash point ventilated area. Never spray near naked flames. Always wear protective face mask, goggles, gloves & ear protectors when using your spray gun. Mask the areas of the item that you do not want to spray and protect any adjacent areas that c...
1) only apply one coat at a time. If more than one coat is required follow the paint manufacturer’s instructions for drying times. 2) if spraying small objects keep the output setting low as this will avoid excessive use of paint and will minimise overspray. 3) when spraying large areas or objects u...
8 rinse the spray gun paint container with the thinner that was used and spray through the spray gun onto cardboard or newspaper. Remove the top knob, slightly push the nozzle towards the switch and pull down and forward to release the piston cylinder assembly from the main spray gun assembly. Remov...
9 thoroughly clean all of these parts. Lightly oil the piston and slide it in and out of the cylinder to distribute the oil over the mating parts, reassemble all of the components to their original positions. Please be aware that certain parts of this spray gun will wear, requiring replacement and t...
10 problem cause action required spray gun hums but does not operate piston sticking (4) remove the large knob at the top of the unit. Pull nozzle and piston assembly down and back to release from main gun assembly. Unscrew and remove nozzle. Remove valve assembly. Insert the metal punch, supplied i...
11 this unit is a class ii appliance which means it is double insulated for your protection, no earthing wire is necessary. If the supply cord is damaged, it must be replaced by earlex ltd or our appointed agents. Your unit has been supplied with a mains lead with a fitted fused plug. Please read th...
Notes.
