Operating instructions thank you for purchasing the earlex spray system kit. This is a highly versatile spray kit and can be used on a variety of applications. Before use - please read the safety & operating instructions. Please retain for future reference earlex ltd. Will accept no responsibility f...
2 safety operating instructions please read before use l never under any circumstances aim the nozzle at another person or animal. In the event of injury occurring seek expert medical advice immediately. L the spray gun must only be used with paints and solvents that have a suitable flash point for ...
3 exploded parts view parts list key description part no. 01. Air cap ring l0215 02. Air cap l0205 03. Spray direction plate l0206 04. Fluid tip (2.0mm) l0237 05. Fluid tip seal l0211 06. Trigger pin l0209 07. Trigger l0202 08. Fluid needle (2.0mm) l0236 6 1 2 0 l g n ir p s . 9 0 key description pa...
4 introduction hvlp stands for high volume, low pressure. This is a type of spraying that allows you to spray extremely accurately but without all the overspray that occurs with the high pressure tank type equipment. In fact, in some parts of the world the high pressure systems are banned by law on ...
5 operation fill the paint container with the material to be sprayed. Do not overfill above max level indicator. Push the fluid tube firmly into the base of the spray gun body. Screw the container onto the gun body tightly. Place the motor unit onto a clean surface, free from any loose debris or liq...
6 helpful hints 1. Evenly control the speed of movement of the spray gun. A fast speed will give a thin coat and a slow speed will give a thick coat. 2. Only apply one coat at a time. If a further coat is required follow the paint manufacturer’s instructions for drying times. 3. If spraying small ar...
7 turbine unit the turbine unit only requires minimal maintenance l ensure the filter (18) is kept clean at all times. This can be washed out if necessary and replaced when dry. From time to time this filter will need replacing. L the turbine bearings are sealed and lubricated for life. There is no ...
© 2007 earlex ltd. L0482 03/07 8 mains connection this unit is a class ii appliance which means it is double insulated for your protection, no earthing wire is necessary. If the supply cord is damaged, it must be replaced by earlex ltd or our appointed agents. Your unit has been supplied with a main...
