Earlex TS20 Instruction Manual - page 3
3
1. Remove all contents from box.
2. Insert end of hose to turbine.
3. Insert hose into spray gun. Push completely
in with slight pressure.
4. Fill cup with solution up to the 4 oz mark.
Use NO MORE than 2 oz per application
applied in two 1 oz coats. Follow the
“Simple Spray Gun Setup Instructions” to
properly set your spray gun up for proper
application. Turn unit on. Test the spray
pattern width on a white cotton towel.
Spray no more than 4 inches away, this
is the same distance you will use when
doing an actual application. Keep the
turbine as far away as possible from the
spray area. The turbine consumes large
volumes of air and if too close this can
cause the turbine to “inhale” the tanning
solution overspray and can cause damage
to the unit. The ON/OFF Switch is located
on the Top of the turbine unit. You will hear
a sound similar to a vacuum cleaner. You
may also notice that air is now blowing
out of the front of the spray gun. This is
correct. Air will continually flow from the
air cap of the spray gun as long as the
turbine unit is running and the air hose
is connected.
SIMPLE SPRAY GUN SETUP INSTRUCTIONS
PROPERSETUPWILLMAKETHEDIFFERENCE
BETWEEN A GREAT APPLICATION AND A
HORRIBLEAPPLICATION.
1. Locate the Solution
Flow Screw on the
backofthespraygun.
Part#8
2. Turn Clockwise to
“Close”andreducethe
spray pattern width, turn counterclockwise
to“Open”andincreasespraypatternwidth.
3. Your goal is a 4 inch wide spray pattern
spraying4inchesawayfromtheclient’sbody.
Testonawhite(light)toweluntilthissetting
isachieved.Awiderpatternwillonlywaste
product. Spraying further away only makes
a mess and again wastes product. THIS IS
THERECOMMENDEDWAYTOSPRAY!!!!!
4. Locatethe“AirCap”(part#2)onthefrontof
the spray gun. This is where the solution is
sprayedoutofthegun.Youwillseeapairof
“horns”.Whenthesehornsareinthevertical
position,youwillsprayupanddown.When
theseareinthehorizontalposition,youwill
spraylefttoright.
5. Simply loosen the air cap ring (part #1) to
adjustthehornsinyourpreferreddirection.
There is no “correct” way. What works for
youisallthatmatters.Tightentheaircapring
afteradjustment.
Quick Tips:
Use no more than 2 oz per application. Using
more is a waste of product with no benefit.
Always do two (2) coats, 1 oz each coat. A
single heavy coat does not work as well as
two light coats.
Best developed colour results will be achieved
by waiting 8-12 hours after application before
first shower.
Apply very little to hands and feet, too much
on these areas never works!!
Your application time should take no longer
than 5 minutes; you will be able to achieve a
2-3 minute application with practice.
If you see “runs” or “beading”... you are
probably going to slow... MOVE THE GUN
FASTER OR ADJUST SOLUTION FLOW
SCREW.
Rinse your spray gun with warm water after
use, that’s all that is needed to keep your
gun clean.
SETUP AND USING YOUR TS20
HORNSIN
VERTICALPOSITION
(SprayUpandDown)
HORNSIN
HORIZONTALPOSITION
(SprayLefttoRight)