EarthCore ISF-SBVT24VE(N,P) Installation & Owner's Manual - page 12
12
REFER TO THE PARTS LIST WHEN FOLLOWING THESE
INSTRUCTIONS.
24/30 burner model shown here.
BURNER INSTALLATION
1.
MAKE SURE THE FIREPLACE GAS SUPPLY IS TURNED OFF.
2.
Locate the gas-supply stub inside the fi replace and remove the
cap, if attached (reference Fig. 12-1).
CAUTION:
When removing the cap, make sure the stub does not
turn, loosening the connection inside the wall.
3.
Place the burner system in the fi replace. Center the burner from
left to right in the fi replace. (Reference Fig. 12-2 for orientation.)
Note:
Ensure the porcelainized panel is clean of all dust. Use a
clean soft cloth if necessary. See Fig. 12-3.
4. Be sure gas to the fi replace is off.
Remove the adapter
connected to the fl ex connector (pre-installed on the burner
system). Attach the adapter to the gas-supply stub using a pipe
compound resistant to all gasses. Tighten securely. Then attach
the open end of the fl ex connector to the adapter. Tighten securely
(see Fig. 12-1).
5.
LEAK TEST: Turn on the fi replace gas supply, and test at all
connections for leaks using the appropriate soapy water solution.
If bubbles appear, a leak is present. Turn off the gas and tighten
at all connections. Repeat until no leaks are present. If a leak
persists, turn off the gas supply and contact the local gas company
or dealer. NEVER USE A FLAME TO CHECK FOR LEAKS.
6.
At this stage the burner system batteries are to be installed.
Reference the INSTALLING/REPLACING BATTERIES section
for details.
7. Place the switch box on its side, at the rear left corner of
the fi replace.
It should rest with its bottom as near as possible
and facing the fi replace wall. It must not be placed directly next
to the burner pan area to avoid damage to the batteries. See
Fig. 12-2 & Fig. 12-4.
Important:
Ensure that the box wire remains away from the burner
system and its fl ame during operation.
The ISOFLAMES burner system must be installed by a qualifi ed professional service technician.
Instructions
must be followed carefully to ensure proper performance and full benefi t from the burner system.
Check to be
sure the burner system is designed and labeled for the type of gas (natural or propane gas) supplied to
the fi replace. Fireplace fl oor must be level, clean, and smooth (see FIREPLACE SAFETY INFORMATION
section).
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts
specifi cally approved with this appliance may result in property damage or personal injury.
INSTALLATION
Fig. 12-2
Place switch box
Fig. 12-1
Connect gas supply
Flex connector
Adapter
Gas supply stub
Fig. 12-3
Ensure a clean panel
Keep clean and DO NOT
cover with embers
Fig. 12-4
Proper box placement
Place switch box:
•
Rear left corner, on side,
•
exposed side against fi replace wall
DO NOT
place box
in this area
Place switch box