EarthQuake PH10000W/D1 Owner's Manual - page 6

PHD2200W.4

10

11

Two 30A Fuses

Speaker 

Outputs

Minimum

4 Ohm

Mono

The gain knob is not a volume control. 

It is designed to match the input level 

of  the  amp  to  the  output  level  of  the 

source unit. Over driving -clipping- the 

input  stage  of  the  amp  will  cause 

damage to the amplifier (Please refer 

to table for settings).

3-way switch feeds, RCA outputs

3/4 a full range, high-pass or low-

pass signal.

3-way switch for each block

runs CH1/2 or CH3/4 in low

-pass, full-range or high-

pass mode.

Tonal controls CH3/4:

+ 12dB boost @ 12kHz

+ 18dB boost @ 45Hz

Four RCA level inputs

with a range of 0.2V to 

5V. RMS.

Four RCA level inputs 

crossed outputs, can be 

used to feed other 

amplifiers in the system

Set Xover knob to 

Minimum (20Hz), &

set Xover switch to

by-pass, (full-range)

Specifications Are Subject To Change Without Notice

www.earthquakesound.com

POWER

To car chassis / ground

To remote turn on / trigger

To battery (+)

REM GND

BAT