1. DL manuals
  2. EarthQuake
  3. Monitor
  4. Studioquake M6
  5. User Manual

EarthQuake Studioquake M6 User Manual

Summary of Studioquake M6

  • Page 2

    Safety instructions introduction amplifier features placing your studioquakes troubleshooting specifications notes 3-4 5 6 - 7 8 - 9 10 - 11 12 13 customer support support@earthquakesound.Dk tel: +45 2043 8007 web: www.Earthquakesound.Eu www.Earthquakesound.Dk earthquake europe mogensensvej 29 5000 od...

  • Page 3

    Thank you for purchasing the studioquake series of powered studio monitors: studioquake m6 and/or studioquake m8. Building on the legacy of the iquake series the new studioquake line continues the quest to be the best powered monitor speaker on the market today. With a focus honed on audio quality t...

  • Page 4

    Pin 1 ↔ sleeve (shield) = ground (cable shield) pin 2 ↔ tip = positive/red/hot pin 3 ↔ ring = negative/black/cold this volume knob controls the studioquake monitor’s input sensitivity. Typically, you would want to set this knob to the maximum setting (+6db), adjust the source’s output level and then...

  • Page 5

    Placing yout studioquake monitors proper placement of your studioquake studio monitors is crucial to their performance. Studio/stereo application we suggest placing the monitors within the front 1/3 of the room, about 3 to 5 feet away from each other and directed at a 60 degree angle towards the lis...

  • Page 6

    11 the front led does not light up ➞ inspect the power cable. Never use one that has been altered in any way. ➞verify the power ac outlet is active and supplying the appropriate ac voltage. ➞verify the monitor’s ac selector is at the proper setting with the correct fuse installed (refer to page 7 fo...

  • Page 7

    2 3 1 2 3 1 specifications studioquake m6 studioquake m8 2-way configuration system type hf driver lf driver frequency range (-10db) crossover frequency power rating (hf/lf) peak spl subsonic filter connectors controls dimensions fuse rating active monitor 2” ribbon tweeter 6.5” aramid glass fiber 8” ...