EarthQuake Studioquake M6 User Manual - page 4
Pin 1 ↔ Sleeve (Shield) = Ground (cable shield)
Pin 2 ↔ Tip = Positive/Red/Hot
Pin 3 ↔ Ring = Negative/Black/Cold
This volume knob controls the StudioQuake monitor’s input
sensitivity. Typically, you would want to set this knob to the
maximum setting (+6dB), adjust the source’s output level
and then use this volume knob to match the left and right
StudioQuake Monitors.
This switch controls the AC power going to the
StudioQuake monitor. We suggest keeping the switch in
the OFF position when the monitor is not being used for an
extended period of time.
The StudioQuake monitors can operate in a 110-120V or
220-240V environment. Simply slide the selector to the
required power input setting and replace the fuse to the
proper rating prior to connecting the monitors to the power
source.
RCA input for connecting the StudioQuake monitor to your
TV, computer, DJ equipment, mobile device, etc.
10kOhm balanced TRS input for connecting the
StudioQuake monitor to your audio interface or mixer. For
best result, be sure to use a balanced 1/4” TRS phone plug.
10kOhm balanced XLR input for connecting the
StudioQuake monitor to your audio interface or mixer.
4. Main Power Switch
5. 110V/220V Selector Switch
6. AC Power Inlet with Fuse Holder
7. Volume Control
8. HF Adjustment
This high frequency adjustment is factory set at 0dB.
Simply adjust accordingly to your listening preference.
USE OF IMPROPER VOLTAGE MAY RESULT IN
HAZARDOUS CONDITIONS AND/OR DAMAGE TO THE
MONITOR COMPONENTS THAT ARE NOT COVERED
BY THE FACTORY WARRANTY.
FOR YOUR SAFETY, PLEASE MAKE SURE THAT THE
MONITOR IS NOT CONNECTED TO ANY POWER
SOURCE PRIOR TO ACCESSING THE AC SELECTOR
AND FUSE COMPARTMENT.
This AC line connector is fused to protect the amplifier from
unwanted power surges. Be sure to use the proper fuse
rating when replacing the existing fuse:
M6: ø5 x 20mm 2A/250V UL/VDE slow blow tube fuse
M8: ø5 x 20mm 3.15A/250V UL/VDE slow blow tube fuse
To access the fuse compartment, simply
unplug the power cable from the monitor,
place a flat-head screw driver in the small
notch and pry it open as illustrated.
6
7
Amplifier Features
1. Unbalanced RCA Input
2. Balanced 1/4” TRS Input
3. Balanced XLR Input
NOTE:
CONNECT ONLY ONE INPUT SOURCE AT A TIME.
2
3
1
Sleeve
Ring
Tip
Balanced TRS
Unbalanced TS
2
3
1
US핇ONLY WITH A틖250V FUSE
US핇ONLY WITH A틖250V FUSE
US핇ONLY WITH A틖250V FUSE
2
3
1
1
2
3
4
5
6
7
8
뜽뭗B
Earthquake Europe | support@earthquakesound.dk | www.earthquakesound.eu
Specifications are subject to change without notice