EarthQuake XJ-1000FR User manual - P R O
Front Panel
Rear Panel
1
2
6
7
14
13
13
12
11
10
8
9
9
15
page 6
P R O
www.earthquakesound.com
Front / Rear Panels
XJ-1000 FR
ON/OFF control
Function operation
keys
Mute control
Preset EQ
mode Select
Directly back to the
IR CONTROL: NEC PROTOCOL
CUSTOMER CODE: 00HFFH
main screen
Store hot key
Recall hot key
Remote Control
8
1- Power Switch: turns amplifier ON / OFF. Amplifier must be ON for the 12V
trigger and the music auto sensing modes / functions to operate.
2- Remote Eye: receives remote control signal.
3- Potect LED: “RED” color indicates that amplifier is in protection mode (short
speaker wire or other reasons. Turn OFF the amplifier immediately).
4- Clip LED’s (CH-A & CH-B): “RED” color indicates that the input signal on
the channel/s (A or B) is clipped (reduce volume on the clipped channel).
5- LCD Display Module: shows the amplifier status, menus and settings.
6- Button Switches: represent the functions keys.
7- Encoder Switch: controls the operation of the functions.
8- Left / Right RCA Inputs: feed line-level stereo (left / right) signals into the
amplifier. NOTE: either left or right RCA jacks can be used to feed a mono
input.
9- Left / Right XLR Balanced Inputs: feed balanced line-level stereo
(left/right) signals into the amplifier. NOTE: either left or right XLR jacks can be
used to feed a mono input.
10- Stereo / Bridged Switch: use this control / function when running the
amplifier in bridge or in stereo mode only.
11- External Trigger Input: powers up / triggers ON the amplifier from other
devices such as processors, receivers or any device with 12 Volts trigger
output.
12- USB Port: for operating the amplifier and / or uploading new firmware.
13- Left / Right Speaker Output: for speaker connection (stereo mode or
bridged mode).
14- 110V / 220V AC Voltage Selector: allows the amplifier to operate on 110V-
120V 60Hz and on 220V-240V 50Hz AC.
15- Power Cable Connector: connects amplifier to power source (rated 15
amperes).
CLIP
PROTECT
CH-B
CH-A
3
4
5