EarthQuake XJ-300ST User Manual - Linking 2 Xj-300Sts
Linking 2 XJ-300STs
TRIGGER IN
3
2
1
1
The XJ-300ST’s ingenious design lets the user link two amplifiers together
depending on the desired channel setup.
DO NOT APPLY ANY PRESSURE TO THE FRONT OR
BACKPLATES OF THE AMPLIFIERS AS DOING SO WILL
CAUSE DAMAGE TO THE KNOBS, TOGGLE SWITCHES
AND/OR TERMINALS. AMPLIFIERS DAMAGED IN THIS
MANNER ARE NOT COVERED BY WARRANTY.
1) Line up the linking bolts on one amplifier with the linking holes of the other
amplifier and push them towards each other.
2) Once the linking bolts are in the linking holes, push the amplifier with the
linking bolts towards the faceplate while pushing the other amplifier towards
the backplate to lock the two amplifiers together. The amplifiers are linked
correctly when their faceplates are flush.
3) Install the linking bracket to the backplates of the linked amplifiers for added
reinforcement (as shown below).
10
Earthquake Sound Corp. | www.earthquakesound.com
XJ-300ST Manual