Earthworks PM40T User Manual - page 4
2
ASSEMBLING & DISASSEMBLING THE TOURING PIANOMIC™
The PianoMic™ System is quick and easy to install. Once you have initially set up
the PianoMic™ System you will be able to do it from that point on in just a few
minutes. Here are some helpful guidelines:
CAUTION – the microphone heads and goosenecks are permanently attached to
the two PianoMic™ telescoping tubes and cannot be moved, or removed. Once
assembled, the distance between the two goosenecks is fixed at 16 inches (one-
third of the width of a piano keyboard).
Check that all items are included with your Touring PianoMic™ System by using
the list of “Items Enclosed” on page one of this manual.
TO ASSEMBLE
1. Remove the two PianoMic™ telescoping bars from the case. Notice that on
each of the two telescoping bars, there is a special XLR type connector. There is a
rotating collar next to the special XLR type connector on the telescoping bar that
has a cable coming out of one end, (see Section B in Fig 1-A).
Figure 1-A
Sections A & B of PianoMic
2. Rotate the collar on the XLR connector so it is snug against the connector cover,
but not too tight. (Fig. 1-B)
Figure 1-B
Rotate collar all the way
to the right.
3. Next, rotate the collar two turns in the opposite direction (moving it away from
the connector cover toward the connector pins). (Fig. 1-C)
Figure 1-C
Rotate collar two
turns to the left
11
WARRANTY
All Earthworks products carry a two-year limited warranty (parts and labor). If you have any
problems with your Earthworks products, please contact our warranty/repair department by
email at: returns@earthworksaudio.com or by telephone at (603) 654-6427, Ext. 20.
PianoMic™ Polar Response
Earthworks, Inc.
37 Wilton Rd.
Milford, NH 03055
603-654-6427, ext. 14
www.earthworksaudio.com
Made in U.S.A.
Specifications
Frequency Response:
Polar Pattern:
Sensitivity:
Power requirements:
Peak Acoustic Output:
Output:
Min. Output Load:
Noise:
Mic Gooseneck Length:
Rod Length Assembled:
Rod Length Separated:
Carrying Case :
Product Weight:
Shipping Dimensions:
Shipping Weight:
4Hz - 40kHz
Omnidirectional
(random incidence)
15mV/Pa (-36 dBV/Pa)
48V Phantom, 10mA
148 dB SPL
XLR-3 (pin 2+)
600 ohms (pins 2 & 3)
22dBA
4.875” (12cm)
64”(160cm) fully extended
46”(115cm) fully collapsed
23”(58.4cm) fully collapsed
24.5”x12.5”x4”
(619x317x100 cm)
6 lbs. (2.7 kg)
26”x18”x8” (66x46x20 cm)
13 lbs. (6 kg)
PM40T