Eastwood MIG 135 Assembly And Operating Instructions Manual - page 6
6
© Copyright 2011 Easthill Group, Inc.
WIRE FEEDER INSTALLATION
The wire feed drive roller attached to MIG135 has two wire grooves, one for 0.023” (0.6 mm) welding wire
and another for 0.030 (0.8 mm) welding wire or 0.035” (0.9 mm) fl ux-cored wire. The factory default is the
0.023” (0.6 mm) wire groove. In the event that 0.030” or 0.035” welding wire is to be used, the wire feed
roller should be switched around.
1. Ensure that the MIG135 welding machine
is powered “OFF” and the power cord is
unplugged.
2. Unlock the tension bar (1) and lift up the
rocker arm (2) of the wire feeder.
3. Unscrew the Allen set screws (3) holding the
wire Feed roller with inner Allen wrench.
NOTE: turn feed roller with pliers to access
allen bolt.
4. Take out wire feed roller (4) and fl ip the
wire feed roller so that the 0.8mm mark
is towards you.
5. Reinstall by putting back the wire feed roller
and tightening the Allen set screw.
WELDING WIRE INSTALLATION
The MIG135 welding machine can be used with wire spools of either 8” (200 mm ) in diameter or 4”(100
mm) in diameter. The depth of either spool should not exceed 2.2” (56 mm). There is a 50mm plastic bar-
rel attached to the welding machine. The swing screw can adjust the resistance of the welding wire spool
to keep the wire from loosening.
For installing (See Figure D-1) a wire spool 8”(200 mm) in diameter, attach the spool to the plastic barrel (1).
The position-fi xing pole of the plastic barrel should be aligned with the locating hole of the welding wire spool.
(NOTE: the wire spool will rotate clockwise when wire is in use.)
To install the welding wire spool 4”(100 mm) in diameter (See Figure D-2). Loosen the wing screw (2) and
remove the rotation-stop block (3). Then remove the plastic barrel (1). Install the welding wire spool onto
the metal shaft.
(NOTE: the wire spool will rotate clockwise when wire is in use). Finally, reinstall the rotation-stop block
and the wing screw.
FIG. C
FIG. C
1
1
2
2
3
3
4
4
FIG. D-1
FIG. D-1
1
2
FIG. D-2
FIG. D-2
3
Figure D-1
Use the welder wire board
with 8” (200 mm) in dia.
Figure D-2
Use the welder wire board
with 4” (100 mm) in dia.