Tig 200 ac/dc welder assembly & operating instructions part #12746.
2 eastwood technical assistance: 800.544.5118 >> techelp@eastwood.Com specifications tig welding is the most controllable, efficient and most versatile method of welding many metals including steel, stainless steel, aluminum and more. Your eastwood tig200 welder with high-frequency inverter technolo...
To order parts and supplies: 800.345.1178 >> eastwood.Com 3 safety information flammability hazard • before beginning, make sure the work surface is cleaned of any oils, coatings or other materials which can ignite and or emit dangerous fumes or vapors. • molten metal can be ejected away from the we...
4 eastwood technical assistance: 800.544.5118 >> techelp@eastwood.Com required items before you begin using the eastwood tig welding system, make sure you have the following: • our tig200 is supplied with the popular nema 50p plug, requiring a nema 50 receptacle. If a 220-240 vac, 30 amp outlet is u...
To order parts and supplies: 800.345.1178 >> eastwood.Com 5 components and controls 1. Power switch – the power switch also serves as the overload circuit breaker and is located at the right of the rear panel (fig. C). 2. Amperage (front panel) – set the output amperage knob marked “a” (fig. A) loca...
6 eastwood technical assistance: 800.544.5118 >> techelp@eastwood.Com setup shielding gas connection a shielding gas bottle is not included with your eastwood tig200 but is necessary while tig welding. A shielding gas bottle can be bought at most local welding supply stores. Eastwood recommends the ...
To order parts and supplies: 800.345.1178 >> eastwood.Com 7 preparing to weld torch disassembly/assembly disassembly: 1. Make sure the welder is turned off and unplugged. 2. Remove the back cap from the torch. 3. If there is a tungsten installed in the torch pull it out of the front of the torch 4. ...
8 eastwood technical assistance: 800.544.5118 >> techelp@eastwood.Com settings selection with the materials selected of which you will be welding you can begin to set up the welder for the specific material. 1. Ac/dc – the type of current will need to be selected depending on the type of material be...
Welding important note: these instructions are intended only to provide the user with some familiarity of the eastwood tig200. Tig welding is a highly complex procedure with many variables. If you have no experience with tig welding; it is extremely important to seek the advice of someone experience...
10 eastwood technical assistance: 800.544.5118 >> techelp@eastwood.Com troubleshooting problem cause fix incomplete circuit check ground connection. Make sure that the ground is on a freshly cleaned surface and close to the welding area. It is suggested to weld towards the ground connection. Incorre...
To order parts and supplies: 800.345.1178 >> eastwood.Com 11 troubleshooting.
© copyright 2012 easthill group, inc. Instruction part #12746q rev. 6/12 if you have any questions about the use of this product, please contact the eastwood technical assistance service department: 800.544.5118 >> email: techelp@eastwood.Com the eastwood company 263 shoemaker road, pottstown, pa 19...
