Easy-Lam Green BA-EZ27g User Manual - page 11
11
Make sure to press “Timer Reset” if the machine has been unattended for an
hour or more.
Ensure that the circuit breaker has not tripped
Fuse may have blown. Replace fuse (rear next to power cord)
with 15 amp BUSS (MDA-15) for standard units, or 12 amp
(MDA-12)
for
CSA
units.
PROBLEM:
Laminating film and item being laminated move through
laminator
erratically.
ACTION:
Check thickness of item to be laminated. Maximum thickness is
1/16"
(1.6mm).
Clean heat shoes of residual adhesive. Refer to MAINTENANCE
section
for
cleaning
instructions.
PROBLEM:
Plastic is not bonding to the item or to itself at the edges.
ACTION:
Make sure heat shoes and rollers are at proper operating
temperature and have had time to warm up. See Table 1 for the
suggested temperature ranges. (ensure you are using quality film).
PROBLEM:
Wrinkles on laminated item running parallel with supply
rolls.
ACTION:
Increase roller tension on top and/or bottom supply rolls; only
small amounts between tests.
Reduce
heat
shoe
temperature.
PROBLEM:
Stretch lines appear on laminated items running parallel with
the
outside
edges.
ACTION:
Increase supply mandrel tension on top and/or bottom supply rolls.
Reduce
heat
shoe
temperature.
Clean heat shoes of residual adhesive. See MAINTENANCE
section
for
cleaning
instructions.
PROBLEM:
Blistering of the film appears over the item or along the
edge.
ACTION:
Reduce temperature on heat shoes. If the indicator
light remains on after the adjustment is made, disconnect the
power supply and contact your dealer.
Clean laminating rollers. See MAINTENANCE section for
cleaning
instructions.
There may be moisture in the paper you are laminating. Store
paper in a dry place and be sure that any ink is thoroughly dry
before
laminating.