EasyPro PA10 Installation, Operating And Maintenance Instructions - Assembly:
PA75HP, PA75 and PA100 Aeration Systems ...
The PA75HP system uses a 3/4 horse power high-pres-
sure compressor with 600 feet of tubing and three air
diffusers. It has a maximum operating depth of 90 feet.
The PA75 system uses a 3/4 horse power high-volume
compressor with 800 feet of tubing and four air dif-
fusers. The maximum operating depth is 18 feet.
The PA100 system uses a 1 horse power compressor
with 1000' of tubing and five air diffusers, maximum
operating depth is 18'.
Assembly:
1. Unpack all the parts. Compare parts with packing list below to ensure all parts were
received. If a shortage occurs, please notify us immediately.
2. Screw the round rubber membrane diffuser into the PVC base. Fill base with sand or
small stone.
3. Slide one end of the tubing onto the barbed adapter on the PVC base and secure with a
clamp (provided).
4. Attach the 2' piece of flex pipe into the outlet side of the compressor.
5. Unroll the entire roll of pipe. It is recommended that the pond diffuser be installed at this
point. This will allow you to trim any unused pipe before attaching to the pump. Once
installed and trimmed, attach the other end of the tubing to the flexible hose on the com-
pressor.
6. Connect the valved outlet assembly to the compressor.
7. Connect the tubing to the flex hose on the compressor. Once the compressor is running,
you may have to adjust the valves to equal the air flow to each diffuser. This corrects the
difference in air flow caused by a difference in operating depth and/or tubing lengths.
• The PA100 system installs the same as PA75, it simply has five airlines instead of
four.
PA75HP, PA75 and PA100 Packing List:
The PA75 hp and PA75 aeration
systems are similar except for the
compressor. The PA75HP com-
pressor has a higher pressure rat-
ing for deeper water operation. All
other items and assembly are the
same for these two kits.
After one or two years of opera-
tion, you will possibly notice a sudden drop in air bubbles. This is a sign the compressor
needs new vanes. A rebuild kit is available (Part #RV75V for 3/4 HP compressor, RV100V
for 1 HP) to restore like-new performance. Be sure to keep the air filter clean. Filters can be
washed in soapy water. Replacement filters are available.
7
PA75HP
PA75
PA100
Description
Qty.
Qty.
Qty.
Packed
Air Compressor w/filter
1
1
1
Valved Assembly
1
1
1
Membrane Diffusers
3
4
5
Clamps
6
8
10
200' Rolls Tubing
3
4
5
___ Additional Tubing
Packed By:
Date:
# of Boxes: