EasyRAID Q24P2-U4R4 Hardware manual - page 23

easyRAID Q24P2-U4R4 Serial ATA II Disk Array System

13

2 

 Ba

sic Co

nfigu

ra

tio

n –  

M

oun

ting in a Rack

Mounting in a Rack

When the disk array system is completely set up, it can be installed in a standard 19-inch rack. 

Follow the instructions in this section to install the disk array system in a rack.

1

Clip eight rack nuts supplied with your rack, into the rack, taking care that they corre-

spond with the mounting points on the rails.

2

Extend both of the rails so that they are the right length to fit in your rack. 

3

Bolt the rails into the rack using the rack bolts supplied with your rack.

You will need four nuts and bolts (not included) for each rail; two at the front and two 

at the back.

4

Tighten the locking screws when they are the correct length.

5

Slide the disk array system into the rack and bolt it into place with the supplied fixing 

screws.

Caution

This product is heavy. Attempting to install the disk array system in a 

rack by yourself could result in injury or damage to the product. 

Power P/S Fail Access

Enter              ESC