EasyRAID S16-F2R4 Hardware User Manual - page 26
18
easyRAID S16 Serial ATA Disk Array Systems
2
Basic Con
fig
ur
ation –
Ma
kin
g
Co
nn
ectio
n
s
Making Connections
After the required number of disks have been installed, external connections to the disk array
system must be made. This section describes how to make all of the necessary connections.
Connecting the Host Interface
The disk array system has either dual SCSI interfaces or dual fibre channel interfaces. Refer to
the following sections to make host interface connections.
Small Computer Systems Interface
The ERX16S-U4R4 has dual Ultra320 SCSI interfaces. Follow these instructions to make con-
nections.
1 Connect the active SCSI terminator (A) to the bottom connector of the ERX16S-U4R4
host port 1 (primary SCSI channel) at the rear of the disk array system.
2 Connect the Ultra320 SCSI cable (B) to the top connector of the ERX16S-U4R4 host
port 1 (primary SCSI channel) at the rear of the disk array system.
A
B