EasyRAID S8A2-PETT Hardware User Manual - page 19
Manual is about: PCIe to Serial ATA II
of
32
easyRAID S8A2-PETT Serial ATA II Disk Array Systems
9
2
Ba
sic Co
nfigu
ra
tio
n –
M
a
king
Con
nection
s
Making Connections
After the required number of disks have been installed, external connections to the disk
array system must be made. This section describes how to make all of the necessary
connections.
Connecting the Host Interface
The disk array system has PCIe interface. Refer to the following sections to make host
interface connections.
The easyRAID S8A2-PETT has PCIe interface. Follow these instructions to make con-
nections.
1 Connect the PCIe cable to the left connector of the easyRAID S8A2-PETT host
port 1 at the rear of the disk array system.
Host 1