Eaton 1000VA User And Installation Manual - page 12
18
7. User’s guide to operations
Necessary information for operation of the unit is covered in this chapter.
Normally the UPS runs automatically, but on those few occasions such as just
after installation, all the starting and shutting down procedures are described
herein.
7.1 Starting and shutting down the UPS
Starting the UPS
z Ensure that installation was correct and successful and that the input power cable is
connected to a well-grounded outlet.
z The UPS can be started by pushing the button on the front panel.
z The UPS should now start its inspection of: internal functions, main synchronization and
inverter startup. Then power should start to be supplied via the outlets.
z During this inspection, the LCD will display “Ready on”. The LED shall light up when
output power has commenced and the LCD will display “Line mode”.
z Switch on the loads.
Shutting down the UPS
z Shut down and turn off the loads.
z Push the button on the front panel for five seconds. The alarm will sound and the
UPS will shut down.
z The LCD will display UPS OFF for a few seconds.
z In emergency situations, the EPO located on the back of the unit should be used.
7.2 Button Operation
Please note the three operating buttons on the front panel:
1. “ ” is a ON/ OFF button :
(a). Push the “ ” button (at least 3 seconds) to turn on the UPS.
(b). When UPS is working, push the “ ” button (at least 3 seconds) to turn off the
UPS.
2. “ ” is a Enter button. Use this button to check content of UPS and the method is listed
below:
(a). Push the “ ” button (at least 2 seconds) to check content of UPS. Each content
can be displayed by pressing at once, and it has
fifteen kinds of function to be checked.
(b) If no pressing within 10 seconds, it will return to original status.
3. “ ” is a Function button . Each function can be enabled by pressing this button.
19
(a). Push the “ ” button (at least 2 seconds) to choose which function that you want.
Each content can be displayed by pressing at once, and it has
fourteen
kinds of function to be checked.
(b). After choosing the function, push the “ ” button to enter the function that you
want.
(c). Push the “ ” button to choose other function again.
(d). Push the “ ” button to enable your function.
(e). Push the “ ” button to confirm and enable your function.
(f). If no pressing within 10 seconds, it will return to original status.
7.3 Control Panel functions
Operation of the UPS is indicated on the monitor panel with five LED indicators and an
LCD screen. This display is also capable of alerting the user with audible alarms.
ON/ This green LED is lit when UPS has been turned on.
ON-LINE/ When the UPS is in normal or static bypass modes, there is voltage at the
output terminals and this LED will light up in green.
ON-BAT/ While operating in battery mode.
BYPASS/ While operating in bypass mode, this LED will light up in yellow.
FAULT/ If any internal error occurs in the UPS, this LED will light up in red and
give off an audible alarm. Press any of the buttons on the front panel to
turn off the alarm.