Eaton Crouse-hinds series Instruction Manual - page 7
DRAFT - 04 March 2016
DRAFT - 04 March 2016
INM MTL GECMA RT COM rev 2
7
Marking
Each device is marked in compliance with the Directive and CE marked with the
Notified Body Identification Number.
This information applies to the MTL GECMA RT COM module manufactured
during or after the year 2015.
2 .6 Safety provisions
WARNING!
Use of a COM module assumes that the user has observed the
standard safety provisions in order to prevent incorrect operation of the
module.
WARNING!
The responsibility for planning, installation, commissioning, operation
and maintenance, particularly with respect to applications in explosion
hazard areas, lies with the plant operator.
• Use the module for its intended purpose only. Incorrect or impermissible use or non-
compliance with these operating instructions may invalidate any warranty.
• The MTL GECMA RT COM module may be used in Safe Area, Zone 1 and/or Zone 2
applications corresponding to the Ex marking.
• Modifications and changes to an RT COM module or its components are not permitted
and may affect the safe operation of the module and invalidate the module’s Ex protection.
• The device may only be operated in an undamaged condition.
• Damage can nullify the safe operation of the Ex protection.
• Avoid using aggressive acids or bases when cleaning.
• The MTL GECMA RT COM module must be set up and operated in accordance with the
applicable assembly and installation regulations.
continued on the next page