Eaton ET9200-10-220 Instruction Manual - New Improved Eaton Method

New Improved Eaton Method

With the Eaton hydraulic hose saws the 

hose is positioned across two pins (A) 

and moved into the blade (C) by a feed 

foot (B) using extendable handle (D) 

for better leverage on extremely heavy 

hose. The feed motion causes the hose 

to stretch at the point of contact with 

the blade, allowing it to separate as it is 

cut (see image at below). This separa-

tion allows the hose to pass clear of the 

saw blade with NO friction, NO heat-

ing and NO DEBRIS! A vacuum 

hose (not shown) is attached to a 

vacuum port to remove any tiny 

amount of debris or smoke during 

cutting.

NO DEBRIS

1/8” Clean-Cuts Blade

Pin A

Pin A

Hose separates

as blade slices,

no kerf required.

EC230

EC230

Introduction

Eaton hydraulic hose cutting system is break-through technology using a toothed 

knife, cutting with the backs of each tooth, so the knife does not take a kerf. The saw 

bends the hose into the blade spreading the cut edges to avoid burning and smoking.

Old Method

The normal sawing method of lowering an abrasive 

saw blade onto the hose causes the hose to com-

press and deform. As the blade cuts the compressed 

hosed expands against the blade causing friction, 

heating and burning and much of the debris from the 

kerf of the blade is deposited into your hose.

DEBRIS INSIDE 

YOUR HOSE! 

1/8” Abrasive 

Wheel 

Hydraulic Hose 

EC230

EC230

3

A

D

B

C