Eaton ET9200-10-220 Instruction Manual - Changing The Blade
of
8
Changing the Blade
1. Disconnect Power Plug & logout tagout.
2. Remove hex nuts (right) holding blade
cover and remove cover.
3. Place1⁄4rod/pinthrougharborshaftto
lock saw blade arbor shaft and drive pin
at12o’clock(belowleft).Thiswilllockthe
arbor while the bolt is removed. Please
note that the bolt (below right) to remove
the blade is left hand threaded. To remove
it, turn counter-clockwise.
4. Remove old blade and put new one on over the drive pin (below left) and arbor
shaft. Be sure to follow the blade rotation arrow (below right).
5
5. Placedclampingflangethroughdrive
pin and bolt blade onto the shaft.
Tighten bolt to 20-25 foot/lbs. Do not
over-tighten.Thenremove1⁄4rod/pin
which locks shaft.
6. Replace blade cover and tighten hex
bolts.
ROTATION